Search results
Results from the WOW.Com Content Network
When tube equipment was common, retailers such as drug stores had vacuum tube testers, and sold replacement tubes. Some Nixie tubes were also designed to use sockets. Throughout the tube era, as technology developed, sometimes differently in different parts of the world, many tube bases and sockets came into use.
A few amplifier tubes used two top caps, symmetrically placed, one for anode and the other for grid. 866 mercury rectifier with anode top cap In audio amplifier tube application, the top cap was originally used for the grid connection, and a serviceman could apply a moist finger to the terminal to confirm that the stage and subsequent circuits ...
Continuously transmitting tubes: Maximum anode dissipation in W or kW in Class-C amplifier telegraphy; Pulsed transmitting tubes: Maximum peak anode current in A (number preceded by "P") Rectifiers: Maximum average anode current in mA; Thyratrons: Maximum average anode current: Less than 3 digits: in mA; 3 or more digits: 1st digit: =0 – in mA
In Australia, a T-configuration Clipsal socket is used for extra-low voltage DC power outlets, such as in stand-alone power systems (SAPS) or on boats, in order to prevent accidental connections of 12 V appliances into 240 V socket-outlets. [11] This connector is also used for temporary equipment in emergency vehicles.
These tubes have very similar characteristics to the 6V6, but differ either in the heater rating, or use a different socket and pin-out 5V6GT - Same as the 6V6GT, but with different heater ratings - 4.7V, 0.6A, controlled 11 sec. warm-up time.
A socket with a built-in switch is far more likely to fail in normal use as the switch parts wear out. Insulation failures are usually caused by impacts or by difficulty inserting or removing a lamp. Sockets used outdoors or in damp areas often suffer from corrosion which can cause the lamp to "stick" in the socket and attempts to change a lamp ...
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
RCA 6DS4 "Nuvistor" triode vacuum tube, ca. 20 mm high and 11 mm in diameter Nuvistor with U.S. dime for scale. The nuvistor is a type of vacuum tube announced by RCA in 1959. . Nuvistors were made to compete with the then-new bipolar junction transistors, and were much smaller than conventional tubes of the day, almost approaching the compactness of early discrete transistor casi