Search results
Results from the WOW.Com Content Network
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
The interrupt descriptor table (IDT) is a data structure used by the x86 architecture to implement an interrupt vector table. The IDT is used by the processor to determine the memory addresses of the handlers to be executed on interrupts and exceptions. The details in the description below apply specifically to the x86 architecture.
Load IDTR (Interrupt Descriptor Table Register) from memory. [b] The IDTR controls not just the address/size of the IDT (interrupt Descriptor Table) in protected mode, but the IVT (Interrupt Vector Table) in real mode as well. LMSW r/m16: 0F 01 /6: Load MSW (Machine Status Word) from 16-bit register or memory. [c] [d] CLTS: 0F 06
INT is an assembly language instruction for x86 processors that generates a software interrupt. It takes the interrupt number formatted as a byte value. [1] When written in assembly language, the instruction is written like this: INT X. where X is the software interrupt that should be generated (0-255).
An interrupt vector table (IVT) is a data structure that associates a list of interrupt handlers with a list of interrupt requests in a table of interrupt vectors. Each entry of the interrupt vector table, called an interrupt vector, is the address of an interrupt handler (also known as ISR). While the concept is common across processor ...
The Intel 8086 trap flag and type-1 interrupt response make it quite easy to implement a single-step feature in an 8086-based system. If the trap flag is set, the 8086 will automatically do a type-1 interrupt after each instruction executes. When the 8086 does a type-1 interrupt, it pushes the flag register on the stack.
Any attempt that requires a higher privilege level to perform (ring 0) will produce an interrupt and then be handled using software; this is called "Trap and Emulate". To assist virtualization and reduce overhead caused by the reason above, VT-x and AMD-V allow the guest to run under Ring 0.
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...