Search results
Results from the WOW.Com Content Network
The quarter of a yard (9 inches) was known as the "quarter" without further qualification, while the sixteenth of a yard (2.25 inches) was called a nail. [62] The eighth of a yard (4.5 inches) was sometimes called a finger, [63] but was more commonly referred to simply as an eighth of a yard, while the half-yard (18 inches) was called "half a ...
For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use.From 1893, the foot was legally defined as exactly 1200 ⁄ 3937 m (approximately 0.304 8006 m). [13]
The Greek foot (πούς, pous) had a length of 1 / 600 of a stadion, [12] one stadion being about 181.2 m (594 ft); [13] therefore a foot was, at the time, about 302 mm (11.9 in). Its exact size varied from city to city and could range between 270 mm (10.6 in) and 350 mm (13.8 in), but lengths used for temple construction appear to ...
Re-sawing is the splitting of 1-to-12-inch (25–305 mm) hardwood or softwood lumber into two or more thinner pieces of full-length boards. For example, splitting a 10-foot-long (3.0 m) 2×4 (1 + 1 ⁄ 2 by 3 + 1 ⁄ 2 in or 38 by 89 mm) into two 1×4s (3 ⁄ 4 by 3 + 1 ⁄ 2 in or 19 by 89 mm) of the same length is considered re-sawing.
Comparison of 1 square yard with some Imperial and metric units of area. The square yard (Northern India: gaj, Pakistan: gaz) is an imperial unit and U.S. customary unit of area. It is in widespread use in most of the English-speaking world, particularly the United States, United Kingdom, Canada, Pakistan and India.
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
One acre equals 1 ⁄ 640 (0.0015625) square mile, 4,840 square yards, 43,560 square feet, [2] or about 4,047 square metres (0.4047 hectares) (see below).While all modern variants of the acre contain 4,840 square yards, there are alternative definitions of a yard, so the exact size of an acre depends upon the particular yard on which it is based.
Other lengths may be used—such as 100 metres (330 ft) where SI is favoured or a shorter length for sharper curves. Where degree of curvature is based on 100 units of arc length, the conversion between degree of curvature and radius is Dr = 18000/π ≈ 5729.57795 , where D is degree and r is radius.