Search results
Results from the WOW.Com Content Network
Sidewall deflection is not a direct measurement of rolling friction. A high quality tire with a high quality (and supple) casing will allow for more flex per energy loss than a cheap tire with a stiff sidewall. [citation needed] Again, on a bicycle, a quality tire with a supple casing will still roll easier than a cheap tire with a stiff casing ...
Others may not cut off, but deliver a high rate of flow to fill the larger car tire, with a risk of over inflating and bursting a bicycle tire unless it is stopped with split-second timing. Inflating tubeless tires requires an initial surge of air to seat the bead, and specialized pumps are available specifically for this task. [3]
These two properties are not linearly proportional to the area of the contact. For example, a 10% change in load or inflation pressure usually does not result in a 10% change in the contact patch area [ 3 ] because the load or pressure on a tire can be altered freely, and the contact patch area is affected by the tire geometry and stiffness.
Uneven or accelerated tire wear: can be caused by under-inflation, overloading or poor wheel alignment. Increased tread wear on only one side of a tire: often a sign of poor wheel alignment. Tread worn away completely: especially when the wear on the outer rubber exposes the reinforcing threads within, the tire is said to be bald and must be ...
The Presta valve (also French valve (FV) or Sclaverand valve) is a type of tire valve commonly found on high pressure bicycle inner tubes and is commonly used on tubeless setups. It consists of an outer valve stem and an inner valve body. A lock nut to secure the stem at the wheel rim and a valve cap may also be present.
However, the tire has a lot of vibration when driving over 80 km/h (50 mph). Therefore the tire is only available for golf carts, ATV's and skid steer vehicles. In 2019 however Michelin and GM announced their goal of making a new airless tire for passenger vehicles available in 2024.
An inflator stem is not used; instead, a removable cap on a valve stem embedded in the tire rim is fitted, with only the cap visible. When inflating the tire, the cap is first removed, typically with a coin, and then a "portable" dedicated inflator stem is screwed onto the valve stem. Through the inflator, the tire is inflated as usual.
A beadlock or bead lock is a mechanical device that secures the bead of a tire to the wheel of a vehicle. Tires and wheels are designed so that when the tire is inflated, the tire pressure pushes the bead of the tire against the inside of the wheel rim so that the tire stays on the wheel and the two rotate together.