Search results
Results from the WOW.Com Content Network
Potassium perchlorate in crystal form. Potassium perchlorate is prepared industrially by treating an aqueous solution of sodium perchlorate with potassium chloride.This single precipitation reaction exploits the low solubility of KClO 4, which is about 1/100 as much as the solubility of NaClO 4 (209.6 g/100 mL at 25 °C).
Hodgdon also makes "Triple Seven", a sulfur-free black powder substitute containing potassium perchlorate and 3-Nitrobenzoic acid, and "Black Mag3". [10] These are both more energetic by mass than black powder and can produce higher velocities and pressures.
Any material which, in either concentration tested, exhibits a mean burning time less than or equal to the mean burning time of a 3:7 potassium bromate/cellulose mixture and the criteria for Packing Group I and II are not met. Group I 5.1: Liquid Any material which spontaneously ignites when mixed with cellulose in a 1:1 ratio; or
potassium permanganate with antimony, very slow; Manganese Delay Composition: manganese with lead chromate and barium chromate (lead chromate is the principal oxidizer, barium chromate acts as burning rate modifier, the more of it the slower the reaction) [1] Tungsten Delay Composition: tungsten with barium chromate and potassium perchlorate [2]
Perchlorate concentration was the highest in Chilean nitrate, ranging from 3.3 to 3.98%. [51] Perchlorate in the solid fertilizer ranged from 0.7 to 2.0 mg g −1, variation of less than a factor of 3 and it is estimated that sodium nitrate fertilizers derived from Chilean caliche contain approximately 0.5–2 mg g −1 of perchlorate anion. [74]
The effectiveness of the water gels is dependent on the dissemination of salts in the salt solution. The particles need to be very small and fine so that they can be dispersed well throughout the solution. Some salts that are commonly used include: ammonium nitrate, sodium nitrate, sodium perchlorate and potassium chlorate.
The stoichiometric ratio is 34.2% aluminum and 65.8% perchlorate by mass. A ratio of seven parts potassium perchlorate to three parts dark pyro aluminium is the composition used by most pyrotechnicians. For best results, the aluminium powder should be "Dark Pyro" grade, with a flake particle shape, and a particle size of fewer than 10 micrometres.
The ignition charge of the device is a blend of zirconium, potassium perchlorate, Viton B and graphite, often abbreviated as ZPP. [2] Uses of the device include: Setting off pressure cartridges, pocket sized gas generators which in turn pneumatically activate other systems.