Search results
Results from the WOW.Com Content Network
On a parallel SCSI bus, a device (e.g. host adapter, disk drive) is identified by a "SCSI ID", which is a number in the range 0–7 on a narrow bus and in the range 0–15 on a wide bus. On earlier models a physical jumper or switch controls the SCSI ID of the initiator ( host adapter ).
USB 3.0 SuperSpeed – host controller (xHCI) hardware support, no software overhead for out-of-order commands; USB 2.0 High-speed – enables command queuing in USB 2.0 drives; Streams were added to the USB 3.0 SuperSpeed protocol for supporting UAS out-of-order completions USB 3.0 host controller (xHCI) provides hardware support for streams
Key Code Qualifier is an error-code returned by a SCSI device. When a SCSI target device returns a check condition in response to a command , the initiator usually then issues a SCSI Request Sense command .
Adaptec also developed generic SCSI disk and CD-ROM drivers for DOS (ASPICD.SYS and ASPIDISK.SYS). [3]: 60–61 At least a couple of other programming interfaces for SCSI device drivers competed with ASPI in the early 1990s, including CAM (Common Access Method), developed by Apple; and Layered Device Driver Architecture, developed by Microsoft.
In computer hardware a host controller, host adapter or host bus adapter (HBA) connects a computer system bus which acts as the host system to other network and storage devices. [1] The terms are primarily used to refer to devices for connecting SCSI , SAS , NVMe , Fibre Channel and SATA devices. [ 2 ]
In SAS, both SCSI port identifiers and SCSI device names take the form of a SAS address, which is a 64 bit value, normally in the NAA IEEE Registered format. People sometimes refer to a SCSI port identifier as the SAS address of a device, out of confusion. People sometimes call a SAS address a World Wide Name or WWN, because it is essentially ...
Parallel SCSI (SCSI Parallel Interface SPI) allows for attachment of up to 8 devices (8-bit Narrow SCSI) or 16 devices (16-bit Wide SCSI) to the SCSI bus. The SCSI Host controller takes up one slot on the SCSI bus, which limits the number of devices allowed on the bus to 7 or 15 devices respectively.
Multipath access to a RAID using Linux DM Multipath (Legend: "HBA" = Host bus adapter, "SAN" = Storage area network). In computer storage, multipath I/O is a fault-tolerance and performance-enhancement technique that defines more than one physical path between the CPU in a computer system and its mass-storage devices through the buses, controllers, switches, and bridge devices connecting them.