enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nail (fastener) - Wikipedia

   en.wikipedia.org/wiki/Nail_(fastener)

   Ring shank: small directional rings on the shank to prevent the nail from working back out once driven in; common in drywall, flooring, and pole barn nails Shank : the body the length of the nail between the head and the point; may be smooth, or may have rings or spirals for greater holding power

3. Penny (unit) - Wikipedia

   en.wikipedia.org/wiki/Penny_(unit)

   A larger number indicates a longer nail, shown in the table below. Diameter of the nail also varies based on penny size, depending on nail type. Nails under 1 + 1 ⁄ 4 inch, often called brads, are sold mostly in small packages with only a length designation or with length and wire gauge designations; for example, 1″ 18 ga. or 3 ⁄ 4 ″ 16 ga.

4. Nail gun - Wikipedia

   en.wikipedia.org/wiki/Nail_gun

   Shank styles include plain, ring annular, twisted, etc. and a variety of materials and finishes are offered including plain steel, galvanized steel, sherardised steel, stainless steel, etc. depending on the pull-out resistance, corrosion resistance, etc. required for the given application. These sizes of fastenings are available in stick ...

5. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Square head cap screws up to and including 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 8 inch (3.175 mm) larger than the shank; screws larger than 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 4 inch (6.35 mm) larger than the shank. [9] In 1919, Dyke defined them as screws that are threaded all the way to the head. [10] socket screw

6. Electrogalvanization - Wikipedia

   en.wikipedia.org/wiki/Electrogalvanization

   Electrogalvanizing is a process in which a layer of zinc is bonded to steel to protect against corrosion, enhance adhesion, or give an aesthetic appeal.The process involves electroplating, running a current of electricity through a saline-/zinc-based electrolytic solution with a zinc anode and steel cathode.

7. Barrel threads - Wikipedia

   en.wikipedia.org/wiki/Barrel_threads

   The shank length is not always the same at the thread length, which is the case if the insert has a threadless portion (sub-shank) Tenon designates the thread length; Shoulder designates the barrel diameter in front of the thread portion; Unless otherwise mentioned, right hand threads are assumed. Left hand threads are designated "LH".