Search results
Results from the WOW.Com Content Network
Some examples of primary standards for titration of solutions, based on their high purity, are provided: [4] Arsenic trioxide for making sodium arsenite solution for standardisation of sodium periodate solution (until Ph. Eur. 3, Appendix 2001 also for iodine and cerium(IV) sulfate solutions, since Ph. Eur. 4, 2002 standardised by sodium ...
A titration curve is a curve in graph the x-coordinate of which represents the volume of titrant added since the beginning of the titration, and the y-coordinate of which represents the concentration of the analyte at the corresponding stage of the titration (in an acid–base titration, the y-coordinate usually represents the pH of the solution).
The equipment required is a colorimeter, some cuvettes and a suitable color reagent. The process may be automated, e.g. by the use of an AutoAnalyzer or by flow injection analysis . Recently, colorimetric analyses developed for colorimeters have been adapted for use with plate readers to speed up analysis and reduce the waste stream.
The volumetric titration is based on the same principles as the coulometric titration, except that the anode solution above now is used as the titrant solution. The titrant consists of an alcohol (ROH), base (B), SO 2 and a known concentration of I 2. Pyridine has been used as the base in this case. One mole of I 2 is consumed for each mole of ...
Overshot titrations are a common phenomenon, and refer to a situation where the volume of titrant added during a chemical titration exceeds the amount required to reach the equivalence point. [14] This excess titrant leads to an outcome where the solution becomes slightly more alkaline or over-acidified.
Advantages of Coulometric Titration Coulometric titration has the advantage that constant current sources for the generation of titrants are relatively easy to make. The electrochemical generation of a titrant is much more sensitive and can be much more accurately controlled than the mechanical addition of titrant using a burette drive.
In titrations, the concentration of analyte in solution can be determined by titrating the standard solution against the analyte solution to determine the threshold of neutralization. [9] For example, to calculate the concentration of hydrogen chloride, a standard solution of known concentration, such as 0.5 M sodium hydroxide, is titrated ...
If boric acid (or some other weak acid) was used, direct acid–base titration is done with a strong acid of known concentration. HCl or H 2 SO 4 can be used. Indirect back titration is used instead if strong acids were used to make the standard acid solution: strong base of known concentration (like NaOH) is used to neutralize the solution. In ...