enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Jitter - Wikipedia

    en.wikipedia.org/wiki/Jitter

    Jitter period is the interval between two times of maximum effect (or minimum effect) of a signal characteristic that varies regularly with time. Jitter frequency, the more commonly quoted figure, is its inverse. ITU-T G.810 classifies deviation lower frequencies below 10 Hz as wander and higher frequencies at or above 10 Hz as jitter. [2]

  3. Jitter (optics) - Wikipedia

    en.wikipedia.org/wiki/Jitter_(optics)

    In optics, jitter is used to refer to motion that has high temporal frequency relative to the integration/exposure time. This may result from vibration in an assembly or from the unstable hand of a photographer. Jitter is typically differentiated from smear, which has a lower frequency relative to the integration time. [1]

  4. Unit interval (data transmission) - Wikipedia

    en.wikipedia.org/wiki/Unit_interval_(data...

    Jitter is often measured as a fraction of UI. For example, jitter of 0.01 UI is jitter that moves a signal edge by 1% of the UI duration. The widespread use of UI in jitter measurements comes from the need to apply the same requirements or results to cases of different symbol rates. This can be d

  5. Network performance - Wikipedia

    en.wikipedia.org/wiki/Network_performance

    Jitter is the undesired deviation from true periodicity of an assumed periodic signal in electronics and telecommunications, often in relation to a reference clock source. Jitter may be observed in characteristics such as the frequency of successive pulses, the signal amplitude , or phase of periodic signals.

  6. Wow and flutter measurement - Wikipedia

    en.wikipedia.org/wiki/Wow_and_flutter_measurement

    This measurement quantifies the amount of 'frequency wobble' (caused by speed fluctuations) present in subjectively valid terms. Turntables tend to suffer mainly slow wow. In digital systems, which are locked to crystal oscillators, variations in clock timing are referred to as wander or jitter, depending on speed.

  7. Packet delay variation - Wikipedia

    en.wikipedia.org/wiki/Packet_delay_variation

    Instantaneous packet delay variation is the difference between successive packets—here RFC 3393 does specify the selection criteria—and this is usually what is loosely termed "jitter", although jitter is also sometimes the term used for the variance of the packet delay. As an example, say packets are transmitted every 20 ms.

  8. Radar signal characteristics - Wikipedia

    en.wikipedia.org/wiki/Radar_signal_characteristics

    The formula is derived from the speed of light and the length of the sequence [citation needed]: M U R = ( c ∗ 0.5 ∗ T S P ) {\displaystyle MUR=\left(c*0.5*TSP\right)} where c is the speed of light , usually in metres per microsecond, and TSP is the addition of all the positions of the stagger sequence, usually in microseconds.

  9. Bufferbloat - Wikipedia

    en.wikipedia.org/wiki/Bufferbloat

    Bufferbloat can also cause packet delay variation (also known as jitter), as well as reduce the overall network throughput. When a router or switch is configured to use excessively large buffers, even very high-speed networks can become practically unusable for many interactive applications like voice over IP (VoIP), audio streaming , online ...