Search results
Results from the WOW.Com Content Network
The MTI radar uses low pulse repetition frequency (PRF) to avoid range ambiguities. Moving target indicator (MTI) begins with sampling two successive pulses. Sampling begins immediately after the radar transmit pulse ends. The sampling continues until the next transmit pulse begins.
Pulse-Doppler typically uses medium pulse repetition frequency (PRF) from about 3 kHz to 30 kHz. The range between transmit pulses is 5 km to 50 km. Range and velocity cannot be measured directly using medium PRF, and ambiguity resolution is required to identify true range and speed.
MTI is accomplished by comparing an incoming signal from the current radar pulse with the last one sent, and looking for changes in frequency due to the Doppler shift. This requires the last pulse to be stored so it can be compared with the current one, which is difficult to do at microwave frequencies.
Radar transmission frequency spectrum of a cosine pulse profile. Similarly, the use of a cosine pulse profile has an even more marked effect, with the amplitude of the sidelobes practically becoming negligible. The main lobe is again increased in amplitude and the sidelobes correspondingly reduced, giving a significant improvement in performance.
The goal is to find the optimal space-time weights in -dimensional space, where is the number of antenna elements (our spatial degrees of freedom) and is the number of pulse-repetition interval (PRI) taps (our time degrees of freedom), to maximize the signal-to-interference and noise ratio (SINR). [2]
The pulse-repetition frequency (PRF) is the number of pulses of a repeating signal in a specific time unit. The term is used within a number of technical disciplines, notably radar . In radar, a radio signal of a particular carrier frequency is turned on and off; the term "frequency" refers to the carrier, while the PRF refers to the number of ...
Areas outside the blue zones are blind ranges and blind velocities, which are filled in using multiple PRF and frequency agility. The unambiguous zone is in the lower left corner. All of the other blocks have ambiguous range or ambiguous radial velocity. Pulse Doppler radar relies on medium pulse repetition frequency (PRF) from about 3 kHz to ...
The advantage of combining Doppler processing with pulse radars is to provide accurate velocity information. This velocity is called range-rate. It describes the rate that a target moves toward or away from the radar. A target with no range-rate reflects a frequency near the transmitter frequency and cannot be detected.