Search results
Results from the WOW.Com Content Network
With traditional fixed valve timing, an engine will have a period of "valve overlap" at the end of the exhaust stroke, when both the intake and exhaust valves are open. The intake valve is opened before the exhaust gases have completely left the cylinder, and their considerable velocity assists in drawing in the fresh charge.
The cam can be seen as a device that converts rotational motion to reciprocating (or sometimes oscillating) motion. [clarification needed] [3] A common example is the camshaft of an automobile, which takes the rotary motion of the engine and converts it into the reciprocating motion necessary to operate the intake and exhaust valves of the cylinders.
A camshaft operating two valves. A camshaft is a shaft that contains a row of pointed cams in order to convert rotational motion to reciprocating motion.Camshafts are used in piston engines (to operate the intake and exhaust valves), [1] [2] mechanically controlled ignition systems and early electric motor speed controllers.
Camshafts; Connecting rods (rotating around the piston end as required by the varying horizontal offset between the piston and the crank throw) The imbalances can be caused by either the static mass of individual components or the cylinder layout of the engine, as detailed in the following sections.
For twin-cam or DOHC engines, VCT was used on either the intake or exhaust camshaft. (Engines that have VCT on both camshafts are now designated as Ti-VCT.↓) The use of variable camshaft timing on the exhaust camshaft is for improved emissions, and vehicles with VCT on the exhaust camshaft do not require exhaust gas recirculation (EGR) as retarding the exhaust cam timing achieves the same ...
The uniflow method of scavenging has been often used for two-stroke diesel engines in motor vehicles, marine vessels, railway locomotives and as stationary engines. Its drawback is the additional complexity, mass, volume, and cost required to implement the poppet valvetrain (or the additional crankshaft or rocker arms required to control a ...
The design is similar to the older RTA96C engine, but with common rail technology (in place of traditional camshaft, chain gear, fuel pump and hydraulic actuator systems). This provides maximum performance at lower revolutions per minute (rpm), reduces fuel consumption and emits lower levels of harmful emissions.
The absence of a camshaft also means that the parasitic load on the engine is lower, which is particularly useful in large marine engines, as it can equate to a large amount of power savings. With a camless engine, fuel injection and exhaust timing are directly controlled by an engine control unit and can be constantly changed and adjusted ...