Ad
related to: free car engine sounds like water boiling water vapor effect
Search results
Results from the WOW.Com Content Network
Water is said to "boil" when bubbles of water vapor grow without bound, bursting at the surface. For a vapor bubble to expand, the temperature must be high enough that the vapor pressure exceeds the ambient pressure (the atmospheric pressure, primarily). Below that temperature, a water vapor bubble will shrink and vanish.
Steam (water vapor) will suppress knock even though no added cooling is supplied. Turbulence, as stated, has a very important effect on knock. Engines with good turbulence tend to knock less than engines with poor turbulence. Turbulence occurs not only while the engine is inhaling but also when the mixture is compressed and burned.
In most familiar engines today, this water is circulated from the hot parts of the engine to a radiator, where it gives up its heat to the air. In early and low powered engines with hopper cooling there is little circulation. Water is instead slowly boiled off, with the heat of vaporisation needed to boil the water coming from the engine heat ...
When water flows over a dam spillway, the irregularities on the spillway surface will cause small areas of flow separation in a high-speed flow, and, in these regions, the pressure will be lowered. If the flow velocities are high enough the pressure may fall to below the local vapor pressure of the water and vapor bubbles will form.
If plain water is left to freeze in the block of an engine the water can expand as it freezes. This effect can cause severe internal engine damage due to the expanding of the ice. Development in high-performance aircraft engines required improved coolants with higher boiling points, leading to the adoption of glycol or water-glycol mixtures.
The water fuel cell would split the water into hydrogen and oxygen gas, which would then be combusted back into water vapor in a conventional internal combustion engine to produce net energy.[3] please make these two statements correspond. the main article does not make the (false)statement that, Mr Stanley Meyers claimed engine cylinders ...
Superheated steam was widely used in main line steam locomotives. Saturated steam has three main disadvantages in a steam engine: it contains small droplets of water which have to be periodically drained from the cylinders; being precisely at the boiling point of water for the boiler pressure in use, it inevitably condenses to some extent in the steam pipes and cylinders outside the boiler ...
A water-fuelled car is not any of the following: Water injection, which is a method for cooling the combustion chambers of engines by adding water to the incoming fuel-air mixture, allowing for greater compression ratios and reduced engine knocking (detonation). The hydrogen car, although it often incorporates some of the same elements.
Ad
related to: free car engine sounds like water boiling water vapor effect