enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Ceiling fan - Wikipedia

    en.wikipedia.org/wiki/Ceiling_fan

    Ceiling fans are usually installed in a space with other lighting fixtures, but if the fan is positioned too close to a light panel or fixture, a strobe or flicker effect may occur. A strobe or flicker effect is a phenomenon which occurs when light brightens and dims consistently as it penetrates and passes through a moving ceiling fan. [ 8 ]

  3. Chilled beam - Wikipedia

    en.wikipedia.org/wiki/Chilled_beam

    A chilled beam is a type of radiation/convection HVAC system designed to heat and cool large buildings through the use of water. [1] This method removes most of the zone sensible local heat gains and allows the flow rate of pre-conditioned air from the air handling unit to be reduced, lowering by 60% to 80% the ducted design airflow rate and the equipment capacity requirements.

  4. Industrial fan - Wikipedia

    en.wikipedia.org/wiki/Industrial_fan

    This instantaneous blade adjustment capability is an advantage that is possible with axial fans only. Cooling fans - (also referred to as "cooling tower fans") - These are axial fans, typically with large diameters, for low pressures and large volumes of airflow. Applications are in wet mechanical cooling towers, air-cooled steam condensers ...

  5. Centrifugal fan - Wikipedia

    en.wikipedia.org/wiki/Centrifugal_fan

    Figure 1: Components of a centrifugal fan An external motor belt driven inline centrifugal fan discharging inline to the exterior of a building through a duct. Unlike non-inline/non-concentric impeller casing design with a cutoff blade above, the concentrically symetric cylinder casing and impeller geometry of inline type redirects the outflow around so that it is parallel to the inflow of gases.

  6. Axial fan design - Wikipedia

    en.wikipedia.org/wiki/Axial_fan_design

    An axial fan is a type of fan that causes gas to flow through it in an axial direction, parallel to the shaft about which the blades rotate. The flow is axial at entry and exit. The fan is designed to produce a pressure difference, and hence force, to cause a flow through the fan. Factors which determine the performance of the fan include the ...

  7. Fan (machine) - Wikipedia

    en.wikipedia.org/wiki/Fan_(machine)

    An axial box fan for cooling electrical equipment. Axial-flow fans have blades that force air to move parallel to the shaft about which the blades rotate. This type of fan is used in a wide variety of applications, ranging from small cooling fans for electronics to the giant fans used in cooling towers. Axial flow fans are applied in air ...

  8. High-volume low-speed fan - Wikipedia

    en.wikipedia.org/wiki/High-volume_low-speed_fan

    A high-volume low-speed (HVLS) fan is a type of mechanical fan greater than 7 feet (2.1 m) in diameter. [1] HVLS fans are generally ceiling fans although some are pole mounted. HVLS fans move slowly and distribute large amounts of air at low rotational speed– hence the name "high volume, low speed." Typical applications for HVLS fans fall ...

  9. Radiant heating and cooling - Wikipedia

    en.wikipedia.org/wiki/Radiant_heating_and_cooling

    Radiant cooling systems offer lower energy consumption than conventional cooling systems based on research conducted by the Lawrence Berkeley National Laboratory. Radiant cooling energy savings depend on the climate, but on average across the US savings are in the range of 30% compared to conventional systems.