enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Engine crane - Wikipedia

   en.wikipedia.org/wiki/Engine_crane

   The crane arm, with multiple lengths and weight capacities, has a hook on the end that connects a chain to the engine. The arm of the hydraulic engine hoist raises and lowers with the use of a hydraulic jack, which is operated with a bar that pumps the hydraulic jack to raise the arm. To lower the arm, pressure is released from the hydraulic ...

3. Jack (device) - Wikipedia

   en.wikipedia.org/wiki/Jack_(device)

   Jack which can lift a mobile home. A jack is a mechanical lifting device used to apply great forces or lift heavy loads. A mechanical jack employs a screw thread for lifting heavy equipment. A hydraulic jack uses hydraulic power. [1] The most common form is a car jack, floor jack or garage jack, which lifts vehicles so that maintenance can be ...

4. Car jack - Wikipedia

   en.wikipedia.org/wiki/Car_jack

   Car jack may refer to: Jack (device) , a device for lifting (jacking up) cars and other heavy objects Carjacking , the crime of forcedly repossessing an occupied car

5. Engine stand - Wikipedia

   en.wikipedia.org/wiki/Engine_stand

   Engine stand (red) holding a partially disassembled combustion engine. An engine stand is a tool commonly used to repair large heavy gasoline or diesel engines. It uses a heavy cantilevered support structure to hold the engine in midair so that the mechanic has access to any exposed surface of the engine. They are often referred to as cherry ...

6. Trump’s many civil cases won’t stop just because he’s ...

   www.aol.com/trump-many-civil-cases-won-120043301...

   The DOJ says those actions took place while Trump was head of the federal government, so the government should be able to stand in for him as the defendant, effectively ending plaintiffs’ claims ...

7. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   The R8 system is commonly used with collets ranging in size from 1 ⁄ 8 ″ to 3 ⁄ 4 ″ in diameter or tool holders with the same or slightly larger diameters. The collets or tool holders are placed directly into the spindle and the drawbar is tightened into the top of the collet or tool holder from above the spindle.