enow.com Web Search

  1. Ads

    related to: 100mm tile hole cutter

Search results

  1. Results from the WOW.Com Content Network
  2. Ceramic tile cutter - Wikipedia

    en.wikipedia.org/wiki/Ceramic_tile_cutter

    First Tile Cutter Invented by Boada Brothers. The ceramic tile cutter works by first scratching a straight line across the surface of the tile with a hardened metal wheel and then applying pressure directly below the line and on each side of the line on top. Snapping pressure varies widely, some mass-produced models exerting over 750 kg.

  3. Hole saw - Wikipedia

    en.wikipedia.org/wiki/Hole_saw

    Tungsten carbide hole saw with arbor A 52 mm (2.0 in) hole saw with pilot bit A 115 mm (4.5 in) diamond hole saw. A hole saw (also styled holesaw), also known as a hole cutter, [1] is a saw blade of annular (ring) shape, whose annular kerf creates a hole in the workpiece without having to cut up the core material.

  4. Core drill - Wikipedia

    en.wikipedia.org/wiki/Core_drill

    A modern core drill is a drill specifically designed to remove a cylinder of material, much like a hole saw. The material left inside the drill bit is referred to as the core. Core drills used in metal are called annular cutters. Core drills used for concrete and hard rock generally use industrial diamond grit as the abrasive material and may ...

  5. Drill bit - Wikipedia

    en.wikipedia.org/wiki/Drill_bit

    When the cutting edge is centered on the bit, the hole drilled will be small, and when the cutting edge is slid outwards, a larger hole is drilled. This allows a single drill bit to drill a wide variety of holes, and can take the place of a large, heavy set of different size bits, as well as providing uncommon bit sizes.

  6. Annular cutter - Wikipedia

    en.wikipedia.org/wiki/Annular_cutter

    An annular cutter (also called a core drill, core cutter, broach cutter, trepanning drill, hole saw, or cup-type cutter) is a form of core drill used to create holes in metal. An annular cutter, named after the annulus shape , cuts only a groove at the periphery of the hole and leaves a solid core or slug at the center.

  7. Water jet cutter - Wikipedia

    en.wikipedia.org/wiki/Water_jet_cutter

    For thin materials, the difference in cutting speed for Q1 could be as much as 3 times faster than the speed for Q5. For thicker materials, Q1 could be 6 times faster than Q5. For example, 4 inches (100 mm) thick aluminium Q5 would be 0.72 in/min (18 mm/min) and Q1 would be 4.2 in/min (110 mm/min), 5.8 times faster. [53]

  1. Ads

    related to: 100mm tile hole cutter