Search results
Results from the WOW.Com Content Network
A pressure force due controlled flow areas and supply pressure, often called line pressure; The VFS can be designed such that any of these forces act in either axial direction. If the magnetic force acts opposes the pressure force, then increasing current through the solenoid coil will, at steady-state, cause an increase in VFS output pressure.
The internal clutch actuator in a semi-automatic transmission can be powered by either hydraulic, pneumatic, or electric means. [6] [7] Later examples of clutchless manual transmissions used in road cars include the Saab Sensonic transmission, used in the 900 NG, and the Ferrari Valeo auto-manual transmission, used in the Mondial T.
This torque converter was nominally about 7in. and achieved a torque multiplication of c2.7 to 1. It also used the reaction arm on the stator as in the N360/N600 to increase hydraulic pressure. It was initially announced in Europe as an automatic as the staff at Honda in Europe assumed that it would like the N600 to be fully automatic.
Automated manual transmissions can be semi-automatic or fully-automatic in operation. Several different systems to automate the clutch and/or shifting have been used over the years, but they will generally use one of the following methods of actuation for the clutch and/or shifting: hydraulic or electro-hydraulic actuation, [12] electro-mechanical, [13] pneumatic, [6] [14] [15] electromagnetic ...
This unit was an early semi-automatic transmission, based on the design of a conventional manual transmission, which used a servo-controlled vacuum-operated clutch system, with three different gear shifting modes, at the touch of a button; manual shifting and manual clutch operation (fully manual), manual shifting with automated clutch ...
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
The 4T80-E transmission is electronically controlled and features an automatic overdrive transaxle with an electronically controlled torque converter clutch. The 4T80 originally used a viscous clutch, but this was changed in 2005 to ECCC. [1] [4] [2] [3] The 4T80 is built at Willow Run Transmission in Ypsilanti, Michigan.
The TH400 was phased out for the 1980 models, when the A-727 replaced the TH-400 as the only automatic transmission option for both the SJ Wagoneer/Cherokee wagons and the J-10/J-20 trucks. Internally similar to the Chrysler A-727, the case was one-piece, cast with an AMC pattern bellhousing (not interchangeable with a Chrysler pattern A-727).