enow.com Web Search

  1. Ads

    related to: which jumper cable is negative 5 volt regulator ic 12 32 x

Search results

  1. Results from the WOW.Com Content Network
  2. List of LM-series integrated circuits - Wikipedia

    en.wikipedia.org/wiki/List_of_LM-series...

    Fixed 3 A, 5-volt positive voltage regulator [64] LM325 Yes Dual ±15-volt voltage regulator [65] LM330 5-volt positive voltage regulator, 0.6 V input-output difference [66] LM333 Yes Adjustable 3 A negative voltage regulator (-1.2 V to -32 V) [67] LM137 LM237 LM337 Adjustable 1.5 A negative voltage regulator (-1.2 V to -37 V) [68] LM138 LM338 ...

  3. Jump wire - Wikipedia

    en.wikipedia.org/wiki/Jump_wire

    Stranded 22AWG jump wires with solid tips. A jump wire (also known as jumper, jumper wire, DuPont wire) is an electrical wire, or group of them in a cable, with a connector or pin at each end (or sometimes without them – simply "tinned"), which is normally used to interconnect the components of a breadboard or other prototype or test circuit, internally or with other equipment or components ...

  4. Voltage-regulator tube - Wikipedia

    en.wikipedia.org/wiki/Voltage-regulator_tube

    This jumper could be used in series with the secondary transformer winding. Then, if the tube was removed, rather than leaving the voltage unregulated, the output would turn off. Because the glow discharge is a "statistical" process, a certain amount of electrical noise is introduced into the regulated voltage as the level of ionization varies.

  5. 78xx - Wikipedia

    en.wikipedia.org/wiki/78xx

    The LM78S40 from Fairchild is not part of the 78xx family and does not use the same design. It is a component in switching regulator designs and is not a linear regulator like other 78xx devices. The 7803SR from Datel is a full switching power supply module (designed as a drop-in replacement for 78xx chips), and not a linear regulator like the ...

  6. Reference designator - Wikipedia

    en.wikipedia.org/wiki/Reference_designator

    1A1A44J5 - Unit 1, Assembly 1, Sub-Assembly 44, Jack 5 (J5 is a connector on a box referenced as A44) 1A1A45J333 - Unit 1, Assembly 1, Sub-Assembly 45, Jack 333 (J333 is a connector on a box referenced as A45) A cable connecting these two might be: 1A1W35 - In the assembly A1 is a cable called W35. Connectors on this cable would be designated:

  7. List of vacuum tubes - Wikipedia

    en.wikipedia.org/wiki/List_of_vacuum_tubes

    These tubes were made for home storage battery receivers manufactured during the early to mid-1930s; all have 2.0 volt DC filaments despite the 1-prefix, intended to distinguish them from the 2.5 volt AC heated tubes listed below 1A4-p – Remote-cutoff pentode; 1A4-t – Remote-cutoff tetrode

  1. Ads

    related to: which jumper cable is negative 5 volt regulator ic 12 32 x