Search results
Results from the WOW.Com Content Network
In the Cisco IOS, [1] they are used in several places, for example: To indicate the size of a network or subnet for some routing protocols, such as OSPF. To indicate what IP addresses should be permitted or denied in access control lists (ACLs). A wildcard mask can be thought of as an inverted subnet mask.
The term subnet mask is only used within IPv4. Both IP versions however use the CIDR concept and notation. In this, the IP address is followed by a slash and the number (in decimal) of bits used for the network part, also called the routing prefix. For example, an IPv4 address and its subnet mask may be 192.0.2.1 and 255.255.255.0, respectively.
A special definition exists for the IP address 255.255.255.255. It is the broadcast address of the zero network or 0.0.0.0, which in Internet Protocol standards stands for this network, i.e. the local network. Transmission to this address is limited by definition, in that it is never forwarded by the routers connecting the local network to ...
Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private network Used for local communications within a private network [3] 192.0.0.0/24 192.0.0.0–192.0.0.255 256
A multicast address is a logical identifier for a group of hosts in a computer network that are available to process datagrams or frames intended to be multicast for a designated network service.
They are used by system processes that provide widely used types of network services. On Unix-like operating systems, a process must execute with superuser privileges to be able to bind a network socket to an IP address using one of the well-known ports.
Private addresses are also commonly used in corporate networks which, for security reasons, are not connected directly to the Internet. Often a proxy, SOCKS gateway, or similar devices are used to provide restricted Internet access to network-internal users. Private network addresses are not allocated to any specific organization.
In previous versions of the document, [19] [20] network numbers were 8-bit numbers rather than the 32-bit numbers used in IPv4. At that time, three networks were added that were not listed earlier: 42.rrr.rrr.rrr, 43.rrr.rrr.rrr, and 44.rrr.rrr.rrr. The relevant portion of RFC 790 is reproduced here with minor changes: