Search results
Results from the WOW.Com Content Network
A head's location varies with the height of the water level against the dam. Since there is only an extremely low flow within the reservoir so no water level gradient, the head can be clearly seen: where the farthest watercourse discharges into the reservoir.
Measuring hydraulic head in an artesian aquifer, where the water level is above the ground surface. Hydraulic head or piezometric head is a specific measurement of liquid pressure above a vertical datum. [1] [2] It is usually measured as a liquid surface elevation, expressed in units of length, at the entrance (or bottom) of a piezometer.
Hydraulic head (or piezometric head) is a specific measurement of the potential of water above a vertical datum. [7] It is the height of the free surface of water above a given point beneath the surface. [4] Pumping level is the level of water in the well during pumping. [8] Specific capacity is the well yield per unit of drawdown. [8]
Hydrostatic head is also used as a measure of the waterproofing of a fabric, commonly in clothing and equipment used for outdoor recreation.It is measured as a length (typically millimetres), representing the maximum height of a vertical column of water that could be placed on top of the fabric before water started seeping through the weave.
Pressure head is a component of hydraulic head, in which it is combined with elevation head. When considering dynamic (flowing) systems, there is a third term needed: velocity head. Thus, the three terms of velocity head, elevation head, and pressure head appear in the head equation derived from the Bernoulli equation for incompressible fluids:
For groundwater "potentiometric surface" is a synonym of "piezometric surface" which is an imaginary surface that defines the level to which water in a confined aquifer would rise were it completely pierced with wells. [1] If the potentiometric surface lies above the ground surface, a flowing artesian well results.
Low-head hydro power refers to the development of hydroelectric power where the head is typically less than 20 metres, although precise definitions vary. [1] Head is the vertical height measured between the hydro intake water level and the water level at the point of discharge.
Commonly, in wells tapping unconfined aquifers the water level in a well is used as a proxy for hydraulic head, assuming there is no vertical gradient of pressure. Often only changes in hydraulic head through time are needed, so the constant elevation head term can be left out ( Δh = Δψ ).