enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Phone connector (audio) - Wikipedia

   en.wikipedia.org/wiki/Phone_connector_(audio)

   The US military uses a variety of phone connectors including 9 ⁄ 32-inch (0.281-inch, 7.14 mm) and 1 ⁄ 4-inch (0.25 inch, 6.35 mm) diameter plugs. [42] Commercial and general aviation (GA) civil aircraft headsets often use a pair of phone connectors. A standard 1 ⁄ 4-inch (6.3

3. Coaxial power connector - Wikipedia

   en.wikipedia.org/wiki/Coaxial_power_connector

   Some common DC power connectors. Generic plugs are often described by their inside diameter, such as 2.1 mm DC plugs. After the two common 5.5 mm OD (Outer Diameter) plugs, the next-most common size is 3.5 mm OD with a 1.3 mm ID (Inner Diameter), usually about 9.5 mm in length, although both longer and shorter versions also exist. These 3.5 mm ...

4. DC connector - Wikipedia

   en.wikipedia.org/wiki/DC_connector

   The corresponding notch in the female connector body is 1.8 ± 0.1 mm (0.071 ± 0.004 in) wide and ends at a radius of 6.2 ± 0.1 mm (0.244 ± 0.004 in) from the connector centre. With the angles measured clockwise looking at the female connector (counter-clockwise looking at the male), the various key positions indicate:

5. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   An LCDI cord has a fine wire mesh around the conductors, and circuitry to detect current leaking from the conductors to the mesh, which would happen if the cord were damaged or frayed. The plugs are normal NEMA 5-15, 5-20, 6-15, 6-20, or 6-30 plugs, depending on the air conditioner design, and are typically molded-on designs.

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   A blade connector is a type of single wire, plug-and-socket connection device using a flat conductive blade (plug) that is inserted into a receptacle. Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and uninsulated varieties are available.

7. SMC connector - Wikipedia

   en.wikipedia.org/wiki/SMC_connector

   SMC jack connectors have an external thread while SMC plug connectors have the mating hex nut. The contact dimensions are identical to the snap-fit SMB. Available in 50 ohm and 75 ohm characteristic impedance, they provide an interconnect means for small form factor coaxial cables (e.g. 50 ohm RG-174 , 75 ohm RG-179 ) and printed circuit boards ...