Search results
Results from the WOW.Com Content Network
An axlebox, also known as a journal box in North America, is the mechanical subassembly on each end of the axles under a railway wagon, coach or locomotive; it contains bearings and thus transfers the wagon, coach or locomotive weight to the wheels and rails; the bearing design is typically oil-bathed plain bearings on older rolling stock, or roller bearings on newer rolling stock.
Spiral groove thrust bearings produce the required pressure to keep the bearing surfaces lubricated and separated purely by the pumping effect of the grooves, whereas journal, conical and spherical forms also get extra pressure generation by the hydrodynamic bearing wedge action. When the parts of the bearings are rotated with respect to each ...
If an integral bearing wears out, the item may be replaced or reworked to accept a bushing. Integral bearings were very common in 19th-century machinery, but became progressively less common as interchangeable manufacture became popular. For example, a common integral plain bearing is the hinge, which is both a thrust bearing and a journal bearing.
A bearing surface in mechanical engineering is the area of contact between two objects. It usually is used in reference to bolted joints and bearings, but can be applied to a wide variety of engineering applications. The choice of bearing surface depends on the application, load, speed, and operating conditions, and the design must be able to ...
The lower half of the main bearings are typically held in place by 'bearing caps' which are secured to the engine block using bolts. The basic arrangement is for each bearing cap to have two bolts, but some engines may have four or six bolts per bearing cap (often referred to as "four-bolt mains" or "six-bolt mains" engines).
This setup allows the axle shaft to be the means of propulsion, and also support the weight of the vehicle. The main difference between the full- and semi-floating axle setups is the number of bearings. The semi-floating axle features only one bearing, while the full-floating assembly has bearings on both the inside and outside of the wheel hub.
A cross-bolted bearing is a bearing, usually a crankshaft main bearing of a piston engine, reinforced with additional transverse bolts.Most bearing caps are retained by two bolts, one on each side of the bearing journal, and parallel to the cylinder axis (or, on vee engines, parallel to an axis bisecting the vee angle).
p = bearing pressure(N/MM2) For any given bearing, there is a value for indicated by C, for which the coefficient of friction is at a minimum. The bearing should not be operated at this value of bearing modulus, since a slight decrease in speed or a slight increase in pressure will make the part of a shaft or axle that rests on bearings operate ...