Search results
Results from the WOW.Com Content Network
On a plane with flaperons, the pilot still has the standard separate controls for ailerons and flaps, but the flap control also varies the flaperon's range of movement. A mechanical device called a "mixer" is used to combine the pilot's input into the flaperons. While the use of flaperons rather than ailerons and flaps might seem to be a ...
A raised aileron reduces lift on that wing and a lowered one increases lift, so moving the aileron control in this way causes the left wing to drop and the right wing to rise. This causes the aircraft to roll to the left and begin to turn to the left. Centering the control returns the ailerons to the neutral position, maintaining the bank angle ...
Cockpit controls and instrument panel of a Cessna 182D Skylane. Generally, the primary cockpit flight controls are arranged as follows: [2] A control yoke (also known as a control column), centre stick or side-stick (the latter two also colloquially known as a control or joystick), governs the aircraft's roll and pitch by moving the ailerons (or activating wing warping on some very early ...
ALT1 may be entered if there are faults in the horizontal stabilizer, an elevator, yaw-damper actuation, slat or flap sensor, or a single air data reference fault. [ 7 ] Alternate law 2 (ALT2) loses normal law lateral mode (replaced by roll direct mode and yaw alternate mode) along with pitch attitude protection, bank angle protection and low ...
A single surface on each wing serves both purposes: Used as an aileron, the flaperons left and right are actuated differentially; when used as a flap, both flaperons are actuated downwards. When a flaperon is actuated downward (i.e., used as a flap), there is enough freedom of movement left to be able to still use the aileron function.
Ailerons are similar to flaps (and work the same way), but are intended to provide lateral control, rather than to change the lifting characteristics of both wings together, and so operate differentially – when an aileron on one wing increases the lift, the opposite aileron does not, and will often work to decrease lift.
The right and left ailerons move in opposite directions. However, aileron control will often use two channels to enable mixing of other functions on the transmitter. For example, when they both move downward they can be used as flaps (flaperons), or when they both move upward, as spoilers .
Canted vertical stabilizers are another distinguishing design element, one among several other such elements that enable the Hornet's excellent high angle of attack ability, including oversized horizontal stabilators, oversized trailing-edge flaps that operate as flaperons, large full-length leading-edge slats, and flight control computer ...