Search results
Results from the WOW.Com Content Network
The template is intended for conversion of heights specified in either metres or in feet and inches. Template parameters [Edit template data] Parameter Description Type Status Metres m metre metres meter meters The height in metres. Do not use if feet and inches are specified. Number optional Centimetres cm centimetre centimetres centimeter centimeters The height in centimetres. Do not use if ...
[2] [3] [4] The factor–label method is the sequential application of conversion factors expressed as fractions and arranged so that any dimensional unit appearing in both the numerator and denominator of any of the fractions can be cancelled out until only the desired set of dimensional units is obtained.
See WP:MOSNUM#Unit names and the discussion, and see Pound-foot (torque) and Foot-pound (energy). However, some topics use traditional units that conflict with the above convention. To handle these, Module:Convert/makeunits includes a specials table that adds an "alttype" (alternate type) field to certain whitelisted units.
The National Institute of Standards and Technology formerly contended that customary area units are defined in terms of the square survey foot, not the square international foot, [17] but from 2023 it states that "although historically defined using the U.S. survey foot, the statute mile can be defined using either definition of the foot, as is ...
Under the Harappan linear measures, Indus cities during the Bronze Age used a foot of 13.2 inches (335 mm) and a cubit of 20.8 inches (528 mm). [11] The Egyptian equivalent of the foot—a measure of four palms or 16 digits—was known as the djeser and has been reconstructed as about 30 cm (11.8 in).
The international standard symbol for inch is in (see ISO 31-1, Annex A) but traditionally the inch is denoted by a double prime, which is often approximated by a double quote symbol, and the foot by a prime, which is often approximated by an apostrophe. For example; three feet, two inches can be written as 3 ′ 2″.
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
As well, lumber is still measured in Costa Rica using a system based on 4 vara, or 11 feet, for both round and square wood. With square wood, using inches, the width is multiplied by the depth to get a measurement called pulgadas, or inches. The lumber is charged 'per inch', which is a measurement of 2.2 litres (11 ⁄ 12 board foot).