enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   The 6P2C, 6P4C, and 6P6C modular connectors are probably best known for their use as RJ11, RJ14, and RJ25 non-powered registered jacks, respectively (and 6P4C and 6P6C for powered RJ11 and RJ14, power being delivered on the outer pairs). These interfaces use the same six-position modular connector body but have different numbers of pins installed.

3. ANSI/TIA-568 - Wikipedia

   en.wikipedia.org/wiki/ANSI/TIA-568

   Perhaps the most comprehensive known and most discussed feature of ANSI/TIA-568 is the definition of the pin-to-pair assignments, or pinout, between the pins in a connector (a plug or a socket) and the wires in a cable. Pinouts are critical because cables do not function if the pinouts at their two ends aren't correctly matched.

4. UEXT - Wikipedia

   en.wikipedia.org/wiki/UEXT

   The UEXT connector consists of 10 pins, in a two row by five male pin configuration, with a plastic keyed-shrouded or box header (specifically BH10S). All pins have a spacing of 0.1 inch (2.54 mm). [1] [2] The socket is mated with a 2×5 (10-pin) IDC female connector, and typically connected to a ribbon cable.

5. Telephone jack and plug - Wikipedia

   en.wikipedia.org/wiki/Telephone_jack_and_plug

   6-pin modular (6P4C or 6P2C), 8-pin modular or 3-position weatherproof connector in accord with TIA-1096-A. [Note 9] 4-prong connector [Note 10] Latvia: 6P2C, Polish national 5-pin [Note 1] Lithuania: 6P2C, Polish national 5-pin [Note 1] Liechtenstein: Reichle-connector, 4-pin Swiss telephone plugs [Note 1] Luxembourg

6. Structured cabling - Wikipedia

   en.wikipedia.org/wiki/Structured_cabling

   Structured cabling design and installation is governed by a set of standards that specify wiring data centers, offices, and apartment buildings for data or voice communications using various kinds of cable, most commonly Category 5e (Cat 5e), Category 6 (Cat 6), and fiber-optic cabling and modular connectors.

7. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

8. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Pogo pin connectors. Pogo pin or spring loaded connectors are commonly used in consumer and industrial products, where mechanical resilience and ease of use are priorities. [32] The connector consists of a barrel, a spring, and a plunger. They are in applications such as the MagSafe connector where a quick disconnect is desired for safety.

9. IEC metric screw sized connectors - Wikipedia

   en.wikipedia.org/wiki/IEC_metric_screw_sized...

   M12 A-coded 5-pin connector: For each connector size, the A-coding is the inspecific pinout variant and the only variant defined in varying numbers of pins. Ethernet cable with an M12 X-coded connector in one end and a modular connector in the other.