Search results
Results from the WOW.Com Content Network
Most modern ESCs contain a microcontroller interpreting the input signal and appropriately controlling the motor using a built-in program, or firmware. In some cases it is possible to change the factory built-in firmware for an alternate, publicly available, open source firmware. This is done generally to adapt the ESC to a particular application.
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
The firmware is based on the eLua project, and built on the Espressif Non-OS SDK for ESP8266. It uses many open source projects, such as lua-cjson [9] and SPIFFS, a flash file system for embedded controllers. [10] Due to resource constraints, users need to select the modules relevant for their project and build a firmware tailored to their needs.
This is a list of open-source hardware projects, including computer systems and components, cameras, radio, telephony, science education, machines and tools, robotics, renewable energy, home automation, medical and biotech, automotive, prototyping, test equipment, and musical instruments.
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...
An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle.
Thus the requirements for the microcontroller are determined by the local application, e.g. the drive control. There is a choice of development boards, both from the EtherCAT Slave Controller suppliers and from third party vendors. There are also open-source projects for EtherCAT slave device development boards, such as SOES and ArduCAT.
A board based on the dsPIC33FJ128MC202 microcontroller, with integrated motor control peripherals. Netduino N2 [251] Wilderness Labs [251] Yes Cortex M3 (ARMv7-M) 120 MHz Arduino 69mm x 53mm USB 5V - 9V DC 192 Kb 60 Kb 16 6 6 1/15/2013 120 MHz 32-bit ARM7 microcontroller board with support for the .NET Micro Framework. Pin compatible with ...