Search results
Results from the WOW.Com Content Network
In a horizontal or vertical cable rail, the cables, once tensioned must be rigid enough to prevent a 4-inch sphere passing through it. Factors influencing this rigidity are: the tension of the cable, intermediate posts (or cable spacers) spacing, the diameter of the cable, top rail cap material and the cable to cable spacing. [7]
Stainless-steel cable and fasteners are strong and don’t obscure the view. Contemporary frame systems use plastic-coated steel cables. [6] Glass balusters and glass panels are often used at contemporary architectural projects where unobstructed view is important. [7] All-glass railing without a top rail can be used to maximize the effect. [8]
The size denotes the width of the faceplate for the installed equipment. The rack unit is a measure of vertical spacing and is common to both the 19 and 23-inch racks. Hole spacing is either on 1-inch (25 mm) centers (Western Electric standard), or the same as for 19-inch (482.6 mm) racks (0.625 in or 15.9 mm spacing).
Lighter cable trays are more appropriate in situations where a great number of small cables are used, such as for telephone or computer network cables. These trays may be made of wire mesh, called "cable basket", [2] or be designed in the form of a single central spine (rail) with ribs to support the cable on either side.
Rack with sample component sizes including an A/V half-rack unit. A rack unit (abbreviated U or RU) is a unit of measure defined as 1 + 3 ⁄ 4 inches (44.45 mm). [1] [2] It is most frequently used as a measurement of the overall height of 19-inch and 23-inch rack frames, as well as the height of equipment that mounts in these frames, whereby the height of the frame or equipment is expressed ...
An example of this arrangement is the lower half of the Great Orme Tramway, where the section "above" the passing loop has a three-rail layout (with each pair of adjacent rails having its own conduit which the cable runs through), while the section "below" the passing loop has a two-rail layout (with a single conduit shared by both cars).
Strain relief plate inside an electrical enclosure, mounted on a 35 mm DIN rail shape H Strain relief plate on the end of a cable carrier. Cable strain relief is a mechanical protection for flexible electrical cables, wires, conduits and pneumatic hoses. It is regulated by the European standard EN 62444 (formerly EN 50262. [2]).
Electrical length is widely used with a graphical aid called the Smith chart to solve transmission line calculations. A Smith chart has a scale around the circumference of the circular chart graduated in wavelengths and degrees, which represents the electrical length of the transmission line from the point of measurement to the source or load.