enow.com Web Search

  1. Ad

    related to: wood header size chart supporting floor joists

Search results

  1. Results from the WOW.Com Content Network
  2. Trimmer (construction) - Wikipedia

    en.wikipedia.org/wiki/Trimmer_(construction)

    Trimmers are installed parallel to the primary floor or ceiling joists and support headers, which run perpendicular to the primary joists. [1] [2] It can also refer to a jack stud that supports a header above a window or door opening. Traditionally, a stud which was less than full length was sometimes referred to as a cripple. [3] [4] [5]

  3. Joist - Wikipedia

    en.wikipedia.org/wiki/Joist

    A double floor is a floor framed with joists supported by larger timbers.. In traditional timber framing there may be a single set of joists which carry both a floor and ceiling called a single floor (single joist floor, single framed floor) or two sets of joists, one carrying the floor and another carrying the ceiling called a double floor (double framed floor).

  4. Framing (construction) - Wikipedia

    en.wikipedia.org/wiki/Framing_(construction)

    Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a

  5. Plank (wood) - Wikipedia

    en.wikipedia.org/wiki/Plank_(wood)

    The wood is categorized as a board if its width is less than 2 + 1 ⁄ 2 in (64 mm), and its thickness is less than 1 + 1 ⁄ 2 in (38 mm). A plank used in a building as a horizontal supporting member that runs between foundations, walls, or beams to support a ceiling or floor is called a joist.

  6. Timber framing - Wikipedia

    en.wikipedia.org/wiki/Timber_framing

    The dragon-beam which runs diagonally from one corner to another, and supports the corner posts above and supported by the corner posts below; The jetty beams or joists conform t floor dimensions above, but are at right angles to the jetty-plates that conform to the shorter dimensions of "roof" of the floor below. Jetty beams are mortised at 45 ...

  7. Parallel-strand lumber - Wikipedia

    en.wikipedia.org/wiki/Parallel-strand_lumber

    [citation needed] PSL can be made from any wood species, but Douglas fir, southern pine, western hemlock, and yellow poplar are commonly chosen [9] because of their superior strength. The product is manufactured as a 12-by-12-inch (300 mm × 300 mm) or 12-by-18-inch (300 mm × 460 mm) billet in a rectangular cross-section, which is then ...

  8. Rim joist - Wikipedia

    en.wikipedia.org/wiki/Rim_joist

    Rim joists are not to be confused with end joists, which are the first and last joists at the ends of a row of joists that make up a floor or deck frame. A rim joist's relationship to the joists is similar to what the top or bottom wall plate is to the studs. It is also confusingly called a header (header also refers to other framing components ...

  9. Wall stud - Wikipedia

    en.wikipedia.org/wiki/Wall_stud

    Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.

  1. Ad

    related to: wood header size chart supporting floor joists