Search results
Results from the WOW.Com Content Network
Ampère's original circuital law. In 1820 Danish physicist Hans Christian Ørsted discovered that an electric current creates a magnetic field around it, when he noticed that the needle of a compass next to a wire carrying current turned so that the needle was perpendicular to the wire. [6][7] He investigated and discovered the rules which ...
In magnetostatics, the force of attraction or repulsion between two current -carrying wires (see first figure below) is often called Ampère's force law. The physical origin of this force is that each wire generates a magnetic field, following the Biot–Savart law, and the other wire experiences a magnetic force as a consequence, following the ...
A matrix version of Kirchhoff's current law is the basis of most circuit simulation software, such as SPICE. The current law is used with Ohm's law to perform nodal analysis. The current law is applicable to any lumped network irrespective of the nature of the network; whether unilateral or bilateral, active or passive, linear or non-linear.
The ampere (/ ˈæmpɛər / AM-pair, US: / ˈæmpɪər / AM-peer; [1][2][3] symbol: A), [4] often shortened to amp, [5] is the unit of electric current in the International System of Units (SI). One ampere is equal to 1 coulomb (C) moving past a point per second. [6][7][8] It is named after French mathematician and physicist André-Marie ...
The diagram shows a waveform from a simple class-C circuit without the tuned load. This is called untuned operation, and the analysis of the waveforms shows the massive distortion that appears in the signal. When the proper load (e.g., an inductive-capacitive filter plus a load resistor) is used, two things happen.
The extension of the above considerations confirms that where B is to H, and where J is to ρ, then it necessarily follows from Gauss's law and from the equation of continuity of charge that E is to D i.e. B parallels with E, whereas H parallels with D. Engineering diagram of Boltzmann's Bicykel. Boltzmann's Bicykel model of electromagnetic ...
Series and parallel circuits. A series circuit with a voltage source (such as a battery, or in this case a cell) and three resistance units. Two-terminal components and electrical networks can be connected in series or parallel. The resulting electrical network will have two terminals, and itself can participate in a series or parallel topology.
Fleming's left-hand rule. Fleming's left-hand rule for electric motors is one of a pair of visual mnemonics, the other being Fleming's right-hand rule for generators. [1] [2] [3] They were originated by John Ambrose Fleming, in the late 19th century, as a simple way of working out the direction of motion in an electric motor, or the direction of electric current in an electric generator.