Ads
related to: mercruiser 4 barrel intake manifold raised to power cable assembly systemcrowleymarine.com has been visited by 10K+ users in the past month
walmart.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A unique intake manifold that used the 48 mm (1.9 in) twin-bore throttle body from the 5.7L TPI Corvette engine was used on the engine's top end. [9] The turbocharged 4.3 L (262 cu in) was last used in the GMC Typhoon in the 1993 model year. The engine produced 280 hp (209 kW) at 4400 rpm and 360 lb⋅ft (488 N⋅m) of torque at 3600 rpm.
Aftermarket port fuel injection and re-engineered cylinder heads have been the norm, although parts for the inline-six, such as aftermarket intake manifolds (from a three-carburetor setup or a single 4-barrel carburetor), exhaust headers, and hybrid cylinder heads based on Chevrolet's small-block engine are costlier than those for the small ...
The initial version of the engine produced 360 hp (268 kW) with a single 4-barrel Carter AFB carburetor. The same engine was upped to 380 hp (283 kW) in 1962. A 409 hp (305 kW) version of this engine was also available, developing 1 hp per cubic inch with a dual four-barrel aluminum intake manifold and two Carter
A 4-barrel carburetor was mated to a high-rise, dual plane intake manifold feeding high-flow cylinder heads that are still considered among the best of that era. [ citation needed ] Its big ports used 2.02 in (51 mm) intake and 1.60 in (41 mm) exhaust valves.
It offers the airflow of more expensive heads, at a much lower cost. It does, however, require a specific intake manifold (the L31 has four bolts per head attaching the intake manifold, as opposed to the "traditional" six bolts per head found on older Chevrolet small-blocks). Chevrolet's L31 was replaced by GM's LS-based 5.3L LM7 and 6.0L LQ4.
In an MPI system, there is one fuel injector per cylinder, installed very close to the intake valve(s). In an SPI system, there is only a single fuel injector, usually installed right behind the throttle valve. Modern manifold injection systems are usually MPI systems; SPI systems are now considered obsolete.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Produced from 1958 through 1960, it was only used in Mercury vehicles. It used a 4.30 in × 3.30 in (109.2 mm × 83.8 mm) bore and stroke. Output began at 312 or 330 hp (233 or 246 kW), both with a four-barrel carburetor. The 322 hp (240 kW) was the only output for 1959, and power dropped to 280 hp (209 kW) for the final year.
Ads
related to: mercruiser 4 barrel intake manifold raised to power cable assembly systemcrowleymarine.com has been visited by 10K+ users in the past month
walmart.com has been visited by 1M+ users in the past month