enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Current–voltage characteristic - Wikipedia

    en.wikipedia.org/wiki/Current–voltage...

    These characteristics are also known as I–V curves, referring to the standard symbols for current and voltage. In electronic components with more than two terminals, such as vacuum tubes and transistors , the current–voltage relationship at one pair of terminals may depend on the current or voltage on a third terminal.

  3. LED circuit - Wikipedia

    en.wikipedia.org/wiki/LED_circuit

    The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED. The voltage drop across a lit LED is approximately constant over a wide range of operating current; therefore, a small increase in applied voltage greatly increases the current.

  4. Load line (electronics) - Wikipedia

    en.wikipedia.org/wiki/Load_line_(electronics)

    The points where the characteristic curve and the load line intersect are the possible operating point(s) of the circuit; at these points the current and voltage parameters of both parts of the circuit match. [1] The example at right shows how a load line is used to determine the current and voltage in a simple diode circuit.

  5. Diode modelling - Wikipedia

    en.wikipedia.org/wiki/Diode_modelling

    The real diode now can be replaced with the combined ideal diode, voltage source and resistor and the circuit then is modelled using just linear elements. If the sloped-line segment is tangent to the real diode curve at the Q-point, this approximate circuit has the same small-signal circuit at the Q-point as the real diode.

  6. Shockley diode equation - Wikipedia

    en.wikipedia.org/wiki/Shockley_diode_equation

    Shockley derives an equation for the voltage across a p-n junction in a long article published in 1949. [2] Later he gives a corresponding equation for current as a function of voltage under additional assumptions, which is the equation we call the Shockley ideal diode equation. [3]

  7. Transfer function - Wikipedia

    en.wikipedia.org/wiki/Transfer_function

    In simple cases, this function can be represented as a two-dimensional graph of an independent scalar input versus the dependent scalar output (known as a transfer curve or characteristic curve). Transfer functions for components are used to design and analyze systems assembled from components, particularly using the block diagram technique, in ...

  8. LED lamp - Wikipedia

    en.wikipedia.org/wiki/LED_lamp

    A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

  9. Small-signal model - Wikipedia

    en.wikipedia.org/wiki/Small-signal_model

    The point on the graph of the characteristic curve representing the bias current and voltage is called the quiescent point (Q point). In the above circuits the AC signal is small compared to the bias, representing a small perturbation of the DC voltage or current in the circuit about the Q point.