Search results
Results from the WOW.Com Content Network
On Earth, additional height of fresh water adds a static pressure of about 9.8 kPa per meter (0.098 bar/m) or 0.433 psi per foot of water column height. The static head of a pump is the maximum height (pressure) it can deliver. The capability of the pump at a certain RPM can be read from its Q-H curve (flow vs. height).
Tide tables give the height of the tide above a chart datum making it feasible to calculate the depth of water at a given point and at a given time by adding the charted depth to the height of the tide. One may calculate whether an area that dries is under water by subtracting the drying height from the [given] height calculated from the tide ...
Hydraulic head (or piezometric head) is a specific measurement of the potential of water above a vertical datum. [7] It is the height of the free surface of water above a given point beneath the surface. [4] Pumping level is the level of water in the well during pumping. [8] Specific capacity is the well yield per unit of drawdown. [8]
In fluid dynamics, total dynamic head (TDH) is the work to be done by a pump, per unit weight, per unit volume of fluid.TDH is the total amount of system pressure, measured in feet, where water can flow through a system before gravity takes over, and is essential for pump specification.
Since there is only an extremely low flow within the reservoir so no water level gradient, the head can be clearly seen: where the farthest watercourse discharges into the reservoir. Upstream of the actual reservoir is likely to be a pre-dam , which typically have a constant water level so the head is reinforced.
During uniform flow, the flow depth is known as normal depth (yn). This depth is analogous to the terminal velocity of an object in free fall, where gravity and frictional forces are in balance (Moglen, 2013). [3] Typically, this depth is calculated using the Manning formula. Gradually varied flow occurs when the change in flow depth per change ...
At a basic level, it is typically calculated in metres using the formula: [1] UKC = Charted Depth − Draft-/+ Height of Tide. Ship masters and deck officers can obtain the depth of water from Electronic navigational charts. [5] More dynamic or advanced calculations include safety margins for manoeuvring effects and squat. [7]
Used mainly to determine the minimum water depth for safe passage of a vessel and to calculate the vessel's displacement (obtained from ship's stability tables) so as to determine the mass of cargo on board. Draft, Air – Air Draft/Draught is the distance from the water line to the highest point on a ship (including antennas) while it is ...