Search results
Results from the WOW.Com Content Network
Extended partition tables that are edited with Vista Disk Management should not be edited with Windows XP Disk Management. XP Disk Management may delete these extended partitions without warning. [11] One way to correct these mixed partition tables is to delete all partitions (reboot or reconnect drive) and use only one partition editor on the ...
For example, if Windows Disk Management (Windows 2000/XP, etc.) is used to delete a partition, it will overwrite the first sector (relative sector 0) of the partition before removing it. It still may be possible to restore a FAT or NTFS partition if a backup boot sector is available.
The diskpart utility is used for partitioning internal hard drives but can also format removable media such as flash drives. [4] It has long been possible, theoretically, to partition removable drives – such as flash drives or memory cards – from within Windows NT 4.0 / 2000 / XP; e.g., during system installation.
While in Windows versions up to XP logical partitions within the extended partition were aligned following conventions called "drive geometry" or "CHS", since Windows Vista they are aligned to a 1-MiB boundary. Due to this difference in alignment, the Logical Disk Manager of XP (Disk Management) may delete these extended partitions without ...
That technique only works with primary partitions. In order to install Windows XP it may be necessary to delete the extended partition from the partition table (in the master boot record). However, if you delete the extended partition value in the master boot record then you try to add it back, RPM will delete the first extended boot record.
The FDISK command manipulates hard disk partition tables. The name derives from IBM's habit of calling hard drives fixed disks. FDISK has the ability to display information about, create, and delete DOS partitions or logical DOS drive. It can also install a standard master boot record on the hard drive.
The chkdsk command on Windows XP. CHKDSK can be run from DOS prompt, Windows Explorer, Windows Command Prompt, Windows PowerShell or Recovery Console. [10] On Windows NT operating systems, CHKDSK can also check the disk surface for bad sectors and mark them (in MS-DOS 6.x and Windows 9x, this is a task done by Microsoft ScanDisk).
A block, a contiguous number of bytes, is the minimum unit of storage that is read from and written to a disk by a disk driver.The earliest disk drives had fixed block sizes (e.g. the IBM 350 disk storage unit (of the late 1950s) block size was 100 six-bit characters) but starting with the 1301 [8] IBM marketed subsystems that featured variable block sizes: a particular track could have blocks ...