Search results
Results from the WOW.Com Content Network
Aldila, Inc. is a sports equipment manufacturing company based in Carlsbad, California, United States. The company specializes in OEM and consumer golf club shafts , but also manufactures other carbon fiber products.
The torque tube consists of a large diameter stationary housing between the transmission and rear end that fully encloses a rotating tubular steel or small-diameter solid drive shaft (known colloquially in the U.S. as a "rope drive" [1]) that transmits the power of the engine to a regular or limited-slip differential. [2]
A drive shaft, driveshaft, driving shaft, tailshaft (Australian English), propeller shaft (prop shaft), or Cardan shaft (after Girolamo Cardano) is a component for transmitting mechanical power, torque, and rotation, usually used to connect other components of a drivetrain that cannot be connected directly because of distance or the need to ...
Therefore, the part of the shaft in contact with the bearing slides over the bearing surface. The simplest example of a plain bearing is a shaft rotating in a hole. A simple linear bearing can be a pair of flat surfaces designed to allow motion; e.g., a drawer and the slides it rests on [3] or the ways on the bed of a lathe.
The functions of this design are to change the axis of rotation by 90 degrees (from the propshaft to the half-shafts) and provide a reduction in the gear ratio. The components of the ring-and-pinion differential shown in the schematic diagram on the right are: 1. Output shafts 2. Drive gear 3. Output gears 4. Planetary gears 5. Carrier 6.
An improvised flexible coupling made of car tyre pieces connects the drive shafts of an engine and a water pump. This one is used to cancel out misalignment and dampen vibrations. Rotating coupling. A coupling is a device used to connect two shafts together at their ends for the purpose of transmitting power. The primary purpose of couplings is ...
The following stresses are induced in the shafts. Shear stresses due to the transmission of torque (due to torsional load). Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft. Stresses due to combined torsional and bending loads.
Square keys are used for smaller shafts and rectangular faced keys are used for shaft diameters over 6.5 in (170 mm) or when the wall thickness of the mating hub is an issue. Set screws often accompany parallel keys to lock the mating parts into place. [3] The keyway is a longitudinal slot in both the shaft and mating part.