Search results
Results from the WOW.Com Content Network
In digital circuits, a logic level is one of a finite number of states that a digital signal can inhabit. Logic levels are usually represented by the voltage difference between the signal and ground, although other standards exist. The range of voltage levels that represent each state depends on the logic family being used.
A five level PAM digital signal. In digital electronics, a digital signal is a pulse amplitude modulated signal, i.e. a sequence of fixed-width electrical pulses or light pulses, each occupying one of a discrete number of levels of amplitude. [6] [7] A special case is a logic signal or a binary signal, which varies between a low and a high ...
Current mode logic (CML), or source-coupled logic (SCL), is a digital design style used both for logic gates and for board-level digital signaling of digital data.. The basic principle of CML is that current from a constant current generator is steered between two alternate paths depending on whether a logic zero or logic one is being represented.
The logic was also called a current-mode circuit. [12] It was also used to make the IBM Advanced Solid Logic Technology (ASLT) circuits in the IBM 360/91. [13] [14] [15] Yourke's current switch was a differential amplifier whose input logic levels were different from the output logic levels.
A logic family of monolithic digital integrated circuit devices is a group of electronic logic gates constructed using one of several different designs, usually with compatible logic levels and power supply characteristics within a family. Many logic families were produced as individual components, each containing one or a few related basic ...
Because the voltage levels are higher than logic levels typically used by integrated circuits, special intervening driver circuits are required to translate logic levels. These also protect the device's internal circuitry from short circuits or transients that may appear on the RS-232 interface, and provide sufficient current to comply with the ...
In digital logic circuits, a digital signal is required to be within certain voltage or current limits to represent a '0' or '1' logic level for correct circuit operation; if the signal is within a forbidden intermediate range it may cause faulty behavior in logic gates the signal is applied to. In metastable states, the circuit may be unable ...
As semiconductor technology has progressed, LVCMOS power supply voltage and interface standards for decreasing voltages have been defined by the Joint Electron Device Engineering Council for digital logic levels lower than 5 volts.