Search results
Results from the WOW.Com Content Network
Leather painting differs from leather dyeing in that paint remains only on the surface while dyes are absorbed into the leather. Due to this difference, leather painting techniques are generally not used on items that can or must bend nor on items that receive friction, such as belts and wallets because under these conditions, the paint may crack or wear off.
A leather punch is a hole punch specifically for making holes in leather. The working tip of the punch is a hollow steel cylinder with a sharp circular knife-like edge. The leather piece is placed on a hard surface, which may be a part of the tool set, and the punch is forced through it, cutting out a small circular piece which is discarded.
The only type of leather suitable for carving is vegetable tanned, full grain leather. [citation needed] This is because the vegetable tanning process allows the leather to absorb water, which is used to soften the leather before the carving process, and the grain of the leather is necessary to allow the leather to hold the shape after the carving process is complete.
In sewing and fashion design, a pattern is an original garment from which other garments of a similar style are copied, or the paper or cardboard templates from which the parts of a garment are traced onto fabric before cutting out and assembling (sometimes called paper patterns).
Letter stamps Also known as letter stamps or number stamps , letter punches are used to emboss the impression of a letter or number into a workpiece. They are most common in the reverse image , this allows the result to be immediately readable, regardless if they may be made as a positive image.
Bonded leather, also called reconstituted leather, is a material that uses leather scraps that are shredded and bonded together with polyurethane or latex onto a fiber mesh. The amount of leather fibers in the mix varies from 10% to 90%, affecting the properties of the product.
A clicking machine from 1922, used to die cut leather Schematic of the dinking process. Die cutting is the general process of using a die to shear webs of low-strength materials, such as rubber, fibre, foil, cloth, paper, corrugated fibreboard, chipboard, paperboard, plastics, pressure-sensitive adhesive tapes, foam, and sheet metal.
A single-cut file has one set of parallel teeth while a cross-cut or double-cut file has a second set of cuts forming diamond shaped cutting surfaces. [1] In Swiss-pattern files the teeth are cut at a shallower angle, and are graded by number, with a number 1 file being coarser than a number 2, etc.