enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Telephone jack and plug - Wikipedia

   en.wikipedia.org/wiki/Telephone_jack_and_plug

   For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...

3. Registered jack - Wikipedia

   en.wikipedia.org/wiki/Registered_jack

   It may also use a 6P4C connector, to use an additional wire pair for powering lamps on the telephone set. RJ14 is similar to RJ11, but is wired for two lines and RJ25 has three lines. RJ61 is a similar registered jack for four lines, but uses an 8P8C connector.

4. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   The 6P2C, 6P4C, and 6P6C modular connectors are probably best known for their use as RJ11, RJ14, and RJ25 non-powered registered jacks, respectively (and 6P4C and 6P6C for powered RJ11 and RJ14, power being delivered on the outer pairs). These interfaces use the same six-position modular connector body but have different numbers of pins installed.

5. RJ11 - Wikipedia

   en.wikipedia.org/?title=RJ11&redirect=no

   This page was last edited on 21 November 2023, at 11:00 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   The registered jack or modular jack in RJ11, RJ45 and other similar connectors used for telecommunications and computer networking The telephone jack of manual telephone switchboards , which is the socket fitting the original 1 ⁄ 4 inch (6.35 mm) telephone plug

7. Princess telephone - Wikipedia

   en.wikipedia.org/wiki/Princess_telephone

   In the mid-1970s, AT&T introduced modular connectors for the line cord and handset cords, requiring the RJ11 standard home telephone jack. Most customers who had Princess telephones were converted to modular jacks. In 1983, AT&T was preparing itself for divestiture of the Bell System.