Search results
Results from the WOW.Com Content Network
Open Host Controller Interface (OHCI) [1] is an open standard.. Die shot of a VIA VT6307 Integrated Host Controller used for IEEE 1394A communication. When applied to an IEEE 1394 (also known as FireWire; i.LINK or Lynx) card, OHCI means that the card supports a standard interface to the PC and can be used by the OHCI IEEE 1394 drivers that come with all modern operating systems.
The virtual CD-ROM drive cannot be removed by reformatting because it is presented to the host system as a physical device attached to a USB hub; [3] the official U3 Launchpad Removal Software was available on the U3 website and disabled the virtual CD drive device, leaving only the USB mass storage device active on the U3 USB hub controller ...
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
Installation (or setup) of a computer program (including device drivers and plugins), is the act of making the program ready for execution. Installation refers to the particular configuration of software or hardware with a view to making it usable with the computer. A soft or digital copy of the piece of software (program) is needed to install it.
The ECM is a type of electronic control unit (ECU), which is an embedded system that employs software to determine the required throttle position by calculations from data measured by other sensors, including the accelerator pedal position sensors, engine speed sensor, vehicle speed sensor, and cruise control switches.
USB-IF's Approved Class Specification Documents. Class definitions for Communication Devices 1.2 (.zip file format, size 3.43 MB) Class definitions for Communication Devices 1.1; App Note, Migrating from RS-232 to USB Bridge Specification. Explains the use of USB CDC (Communications Device Class) ACM (Abstract Control Model) to emulate serial ...
A host of functions required for ECU software calibration, such as interface-dependent calibration methods, calibration data management, measurement data visualization and analysis, ECU programming, vehicle bus monitoring, as well as remote control through standard interfaces, are part of the product's functional complement.
EMCO Remote Installer allows auditing software and OS updates installed on remote PCs. [4] The application extracts information about the installed software from remote PCs and stores it in a database enabling the user to generate software inventory reports. The collected software inventory information is used to uninstall applications and updates.