enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fraction - Wikipedia

   en.wikipedia.org/wiki/Fraction

   For repeating patterns that begin immediately after the decimal point, the result of the conversion is the fraction with the pattern as a numerator, and the same number of nines as a denominator. For example: 0. 5 = 5/9 0. 62 = 62/99 0. 264 = 264/999 0. 6291 = 6291/9999

3. Brannock Device - Wikipedia

   en.wikipedia.org/wiki/Brannock_Device

   Brannock spent two years developing a simple means of measuring the length, width, and arch length of the human foot. He eventually improved on the wooden RITZ Stick, the industry standard of the day, [ 2 ] patenting his first prototype in 1925 [ 3 ] and an improved version in 1927. [ 1 ]

4. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths). (Decimal places for .25, .5, and .75 are shown to thousandths [.250, .500, .750], which is how machinists usually think about them ["two-fifty", "five hundred", "seven-fifty"]. Machinists generally ...

5. Conversion of units - Wikipedia

   en.wikipedia.org/wiki/Conversion_of_units

   Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.

6. Inch - Wikipedia

   en.wikipedia.org/wiki/Inch

   Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as ⁠2 + 3 / 8 ⁠ ″ and not as 2.375″ nor as ⁠2 + 6 / 16 ⁠ ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...

7. Orders of magnitude (length) - Wikipedia

   en.wikipedia.org/wiki/Orders_of_magnitude_(length)

   11 cm = 1.1 dm – length of an average potato in the US; 13 cm = 1.3 dm – body length of a Goliath birdeater; 15 cm = 1.5 dm – approximate size of largest beetle species; 19 cm = 1.9 dm – length of a banana; 26.3 cm = 2.6 dm – length of average male human foot; 29.98 cm = 2.998 dm – distance light in vacuum travels in one nanosecond

8. Image sensor format - Wikipedia

   en.wikipedia.org/wiki/Image_sensor_format

   Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.

9. Micrometer (device) - Wikipedia

   en.wikipedia.org/wiki/Micrometer_(device)

   Modern micrometer with a reading of 1.639 ± 0.005 mm. Assuming no zero error, this is also the measurement. (One may need to enlarge the image to read it.) Outside, inside, and depth micrometers. The outside micrometer has a unit conversion chart between fractional and decimal inch measurements etched onto the frame