Search results
Results from the WOW.Com Content Network
The first Princeton, the "Woody" (so called for its uncovered wooden cabinet), was the smallest of the original Fender line of three amplifiers, an incredibly basic 3-watt practice amp with no controls at all, not even a power switch. [2] The first widely produced Princeton, the 1948 tweed-covered "TV front," used one 6SL7 or 6SC7 dual-triode ...
The power connector on the 3½-inch floppy drive, informally known as "the Berg connector", is 2.50 mm pitch (distance from center to center of pins). The power cable from the ATX power supply consists of 20 AWG wire to a 4-pin female connector. [ 1 ]
Port 1 is the input port where power is applied. Port 3 is the coupled port where a portion of the power applied to port 1 appears. Port 2 is the transmitted port where the power from port 1 is outputted, less the portion that went to port 3. Directional couplers are frequently symmetrical so there also exists port 4, the isolated port. A ...
The Princeton University Tiger Transit fleet is operated by WeDriveU, which has operated the service since February 2021 when the former operator First Transit lost their contract. [ 1 ] [ 2 ] [ 3 ] [ 5 ] The initial fleet under WeDriveU consisted of 14 New Flyer D40LF transit buses from Orange County Transportation Authority and various Ford ...
This is an accepted version of this page This is the latest accepted revision, reviewed on 14 February 2025. Family of electrical connectors Anderson Powerpole Anderson Powerpole 15/30/45 ampere housings and contacts (front view) Type Electrical connector The Anderson Powerpole is a family of electrical connectors by Anderson Power Products (APP), although plug compatible connectors are now ...
A 'universal' cable would have four drive connectors, two for each size of FDD, although cables which have only two drive connectors are common. The cable is normally a ribbon cable . For IBM-compatible floppy controllers, a twist in the cable reverses the order of conductors 10 through 16 for the second connector.
The power connector was typically the same 4-pin female Molex connector used in many other internal computer devices. The communication connectors on the drives were usually a 50 (for 8-bit SCSI) or 68 pin male (for 16-bit SCSI) "IDC header" which has two rows of pins, 0.1 inches (2.54 mm) apart
If the smaller side of this cable is plugged into a "powered" ESATA port, providing both 12 V and 5 V, then the wide end may be plugged into a 2.5" or 3.5" SATA hard drive, supplying the bare drive with both signal and power. The small 2.5" drive will get signal and power at 5 V, which is all that the smaller drive requires, and which the ...