Search results
Results from the WOW.Com Content Network
The insulator has a groove near the top just below the crown. The conductor passes through this groove and is tied to the insulator with annealed wire of the same material as the conductor. Pin-type insulators are used for transmission and distribution of communication signals, and electric power at voltages up to 33 kV.
Aluminum building wiring is a type of electrical wiring for residential construction or houses that uses aluminum electrical conductors. Aluminum provides a better conductivity-to-weight ratio than copper, and therefore is also used for wiring power grids , including overhead power transmission lines and local power distribution lines , as well ...
where is the length of the conductor, measured in metres [m], A is the cross-section area of the conductor measured in square metres [m 2], σ is the electrical conductivity measured in siemens per meter (S·m −1), and ρ is the electrical resistivity (also called specific electrical resistance) of the material, measured in ohm-metres (Ω·m ...
The insulator surrounding the inner conductor may be solid plastic, a foam plastic, or air with spacers supporting the inner wire. The properties of the dielectric insulator determine some of the electrical properties of the cable. A common choice is a solid polyethylene (PE) insulator, used in lower-loss cables.
Tables in electrical safety codes give the maximum allowable current based on size of conductor, voltage potential, insulation type and thickness, and the temperature rating of the cable itself. The allowable current will also be different for wet or dry locations, for hot (attic) or cool (underground) locations.
With this technique, insulator strings, conductor spacers and vibration dampers can be replaced, or lines spliced, without any loss of supply. [ 4 ] The strong electric field surrounding charged equipment is enough to drive a current of approximately 15 μA for each kV·m −1 through a human body. [ 5 ]
High voltage is defined as any voltage over 1000 volts. [3] Those of 2 to 33 kV are usually called medium voltage cables, those over 50 kV high voltage cables.. Modern HV cables have a simple design consisting of a few parts: the conductor, the conductor shield, the insulation, the insulation shield, the metallic shield, and the jacket.
IGS Energy, also known as Interstate Gas Supply, Inc., is an independent retail natural gas and electric supplier based in Dublin, Ohio, United States.It serves more than 1,000,000 residential, commercial and industrial customers in the states of Ohio, Michigan, Kentucky, New York, Pennsylvania, Indiana, Virginia, Maryland, Texas, California, Illinois and Massachusetts.