Search results
Results from the WOW.Com Content Network
In some occasional cases, a sink may have both a potable (drinkable) and a non-potable water supply. Lavatories and water closets normally connect to the water supply by means of a supply , which is a tube, usually of nominal 3/8 in ( United States ) or 10 or 12 mm diameter ( Europe and Middle East ), which connects the water supply to the ...
For premium support please call: 800-290-4726 more ways to reach us
Three Men and a Little Lady is a 1990 American comedy film directed by Emile Ardolino. It is the sequel to the 1987 film Three Men and a Baby . Tom Selleck , Steve Guttenberg , and Ted Danson reprise the leading roles.
The Tool Time girl also assists Tim and Al during the show by bringing them tools. Tool Time was conceived as a parody of the PBS home-improvement show This Old House . [ 6 ] Tim and Al are caricatures of the two principal cast members of This Old House , host Bob Vila and master carpenter Norm Abram . [ 7 ]
Bathrooms are generally categorized as "master bathroom", containing a shower and a bathtub that is adjoining to the largest bedroom; a "full bathroom" (or "full bath"), containing four plumbing fixtures: a toilet and sink, and either a bathtub with a shower, or a bathtub and a separate shower stall; "half bath" (or "powder room") containing ...
The pipes were hollowed-out logs which were tapered at the end with a small hole in which the water would pass through. [23] The multiple pipes were then sealed together with hot animal fat. Wooden pipes were used in Philadelphia, [24] Boston, and Montreal in the 1800s. Built-up wooden tubes were widely used in the US during the 20th century.
Steel pipe is often joined with threaded connections; tapered threads are cut into the end of the pipe, and sealant is applied in the form of thread-sealing compound or thread seal tape (also known as PTFE or Teflon tape) and the pipe is screwed into a threaded fitting with a pipe wrench.
In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.