enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Garden hose - Wikipedia

   en.wikipedia.org/wiki/Garden_hose

   3 ⁄ 4-14NPSH designates female hose ends that mate a hose to a tapered pipe thread without a spigot. The US standard was defined by NFPA 1963, "Standard for Fire Hose Connections", [2] then later by ANSI-ASME B1.20.7, [3] which specifies 1 + 1 ⁄ 16 inches (27 mm) diameter straight (non-tapered) thread with a pitch of 11.5 threads per inch ...

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Piping or tubing is usually inserted into fittings to make connections. Connectors are assigned a gender, abbreviated M or F. An example of this is a "3 ⁄ 4-inch female adapter NPT", which would have a corresponding male connection of the same size and thread standard (in this case also NPT).

4. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   Spigot is used by professionals in the trade (such as plumbers), and typically refers to an outdoor fixture. [1] Silcock (and sillcock), same as "spigot", referring to a "cock" (as in stopcock and petcock) that penetrates a foundation sill. Bib (bibcock, and hose bib or hosebibb), usually a freeze-resistant version of a "spigot".

5. Hose coupling - Wikipedia

   en.wikipedia.org/wiki/Hose_coupling

   Side view of a 1.5 to 2.5 inches (38 to 64 mm) adapter. National Hose thread (NH), also known as National Standard Thread (NST). It is the most common type of fire hose coupling used in the United States. The male and female straight (non-tapered) threads screw together and the connection is sealed with a gasket.

6. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′. The standard for Nominal Pipe Size (often abbreviated NPS, which should not be confused with the abbreviation NPS for the straight thread form standard) is loosely related to the inside diameter of Schedule 40 series of sizes.

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, fine): For 7 ⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw).