Search results
Results from the WOW.Com Content Network
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]
From these figures for the size of a Biblical ell, that of the basic unit—the finger-breadth (Etzba)—can be calculated to be either 2.1 or 2.2 cm (0.83 or 0.87 in); Rav Avraham Chaim Naeh approximates at 2 cm (0.79 in); Talmudic scholar Chazon Ish at 2.38 cm (0.94 in).
The 1/64 scale models will generally have less detail than a 1/16 scale models. [1] Moreover, "1/64 coincides with the S scale of model railroading, part of the consideration of why 1/64 became an established size." [1] Currently, the 1:64 scale is most commonly used for automobiles and other vehicle models.
A ruler with two linear scales: the metric and imperial.It includes shorter minor graduations and longer major graduations. A graduation is a marking used to indicate points on a visual scale, which can be present on a container, a measuring device, or the axes of a line plot, usually one of many along a line or curve, each in the form of short line segments perpendicular to the line or curve.
The best-attested of these is the perch, which varied in length from 10 to 25 feet, with the most common value (16 1 ⁄ 2 feet or 5.03 m) remaining in use until the twentieth century. [1] Later development of the English system continued in 1215 in the Magna Carta. [2] Standards were renewed in 1496, 1588 and 1758. [3]
However, the accepted number of Spanish nautical leagues to a degree varied between 14 1/6 to 16 2/3, so in actual practice the length of a Spanish nautical league was 25,733 feet (4.235 modern nautical miles) to 21,874 feet (3.600 modern nautical miles) respectively. [7]
In the evolutionary approach, the foot was to be derived from these lengths by a simple integer factor, which would be either three (pendulum) or five (rod), i.e. lengthening it from the traditional value of about 304 mm by slightly over 1 inch to ca. 331 mm or shortening it by about a quarter of an inch to ca. 298 mm.