enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Square (tool) - Wikipedia

   en.wikipedia.org/wiki/Square_(tool)

   A square is a tool used for marking and referencing a 90° angle, though mitre squares are used for 45° angles. Squares see common use in woodworking, metalworking, construction and technical drawing. [1] Some squares incorporate a scale for measuring distances (a ruler) or for calculating angles.

3. Combination square - Wikipedia

   en.wikipedia.org/wiki/Combination_square

   The protractor head has a flat reference edge which is attached to an adjustable 180° protractor or (sometimes called a turret) with a graduated scale in both directions for reading both the angle or the complement angle. [1] The protractor head sometimes includes a small spirit level. [4] [2]

4. French curve - Wikipedia

   en.wikipedia.org/wiki/French_curve

   French curves are used in fashion design and sewing alongside hip curves, straight edges and right-angle rulers. Commercial clothing patterns can be personalized for fit by using French curves to draw neckline, sleeve, bust and waist variations.

5. Ruler - Wikipedia

   en.wikipedia.org/wiki/Ruler

   A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]

6. Quilting - Wikipedia

   en.wikipedia.org/wiki/Quilting

   Hand quilting is the process of using a needle and thread to sew a running stitch by hand across the entire area to be quilted. This binds the layers together. This binds the layers together. A quilting frame or hoop is often used to assist in holding the piece being quilted off the quilter's lap.

7. Try square - Wikipedia

   en.wikipedia.org/wiki/Try_square

   Using a try square to mark lines perpendicular to the edge. Using a try square to check if the full length of a board is square. The stock is usually held against the edge of the workpiece and either side of the tongue is then used as a straight edge for making a mark, or as a reference to check the accuracy of an angle.