Search results
Results from the WOW.Com Content Network
If the car's own vapor recovery system is working properly, then the Stage II nozzle will only be vacuuming normal fresh air and depositing that into the gas station's underground fuel storage tanks. That ends up causing evaporation of fuel vapors into the atmosphere, because too much pressure builds up in those fuel storage tanks.
The new regulations required car makers to cut exhaust from cars and light trucks by 25% and from larger trucks and SUVs by 18%, standards that must be met by 2016. [28] The auto industry argued that California's Air Resource Board did not have the authority to adopt such regulation and that the new standards could not be met with the current ...
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
The Clean Air Act of 1963 (CAA) was passed as an extension of the Air Pollution Control Act of 1955, encouraging the federal government via the United States Public Health Service under the then-Department of Health, Education, and Welfare (HEW) to encourage research and development towards reducing pollution and working with states to establish their own emission reduction programs.
A motor vehicle service or tune-up is a series of maintenance procedures carried out at a set time interval or after the vehicle has traveled a certain distance. The service intervals are specified by the vehicle manufacturer in a service schedule and some modern cars display the due date for the next service electronically on the instrument panel.
In the 1979 model year. California vehicles with 2.5, 2.8 and 3.5 liter engines will have a CLCC system. In 1980 model year, vehicles sold in California and 3.8 and 4.3 liter engines sold federally will have CLCC, and finally in the 1981 model year all passenger cars will have the system.
Indirect TPMS (iTPMS) systems do not use physical pressure sensors; they measure air pressures using software-based systems, which by evaluating and combining existing sensor signals such as wheel speeds, accelerometers, and driveline data to estimate and monitor the tire pressure without physical pressure sensors in the wheels.
The MIL will also illuminate if the engine has been cranked but failed to start after returning the ignition to "on". In most modern vehicles this is usually due to not giving the engine enough cranking time to start. In pre-fuel injection years many cranking attempts were sometimes required to start the car.