Search results
Results from the WOW.Com Content Network
A passthrough device is a device used in conjunction with a computer to reprogram vehicle control modules through the OBD-II/CANbus port. [1] Each manufacturer has their own type, but SAE International standardized the J-2534 universal requirements in 2004, requiring all manufacturers to allow vehicles sold in the United States of America and Europe to accept powertrain reprogramming through ...
The €3.49bn (FY2012) project will deliver 630 units at a unit cost of €3.49m (~US$4.8m) for the VCI and €2.74m (~US$3.7m) for the VPC, or €5.5m (~US$7.4m) per vehicle including development costs. [1] The 200th VBCI was delivered to the French army on 23 June 2010. [7] The 400th VBCI was delivered to the French army on 12 June 2012. [8]
[3] The type A connector is used for vehicles that use 12V supply voltage, whereas type B is used for 24V vehicles and it is required to mark the front of the D-shaped area in blue color. The OBD-II connector is required to be within 2 feet (0.61 m) of the steering wheel or, if the manufacturer has applied for an exemption, at least somewhere ...
The AMX-VCI (French: Véhicule de Combat d'Infanterie) is one of the many variants of the French AMX-13 light tank. It was the front line APC of the French Army until replaced by the AMX-10P . It is still used by some countries, for example Mexico, where it goes under the name of DNC-1 and is armed with a 20mm cannon.
A host of functions required for ECU software calibration, such as interface-dependent calibration methods, calibration data management, measurement data visualization and analysis, ECU programming, vehicle bus monitoring, as well as remote control through standard interfaces, are part of the product's functional complement.
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
The VCI, together with the VPI, is used to identify the next destination of a cell as it passes through a series of ATM switches on its way to its destination. The length of the VPI varies according to whether the cell is sent on a user-network interface (at the edge of the network), or if it is sent on a network-network interface (inside the ...
Asynchronous Transfer Mode (ATM), where the circuit is identified by a virtual path identifier (VPI) and virtual channel identifier (VCI) pair. The ATM layer provides unreliable virtual circuits, but the ATM protocol provides for reliability through the ATM adaptation layer (AAL) Service Specific Convergence Sublayer (SSCS) (though it uses the ...