Search results
Results from the WOW.Com Content Network
A vapor barrier on the warm side of the envelope must be combined with a venting path on the cold side of the insulation. This is because no vapor barrier is perfect, and because water may get into the structure, typically from rain. In general, the better the vapor barrier and the drier the conditions, the less venting is required. [7]
Getting rid of water- or oil-based paint stains from carpeting is a hassle. Experts weigh in to provide solutions for removing wet and dry paint stains.
Visqueen is used as a condensation barrier inside walls when installing HVAC systems. It is also used as a ground cover in the crawl space of home foundations as a vapor barrier . [ 3 ] The use of Visqueen underneath a basement is to prevent water infiltration from water present in the ground that would pass through the concrete or dirt floor ...
Water vapor commonly condenses on surfaces cooler than the moisture-laden air, enabling mold to flourish. [citation needed] This moisture vapor passes through walls and ceilings, typically condensing during the winter in climates with a long heating season. Floors over crawl spaces and basements, without vapor barriers or with dirt floors, are ...
Concrete normally allows moisture to pass through so a vertical vapor barrier is needed. Barriers may be a coating or membrane applied to the exterior of the concrete. The coating may be asphalt, asphalt emulsion, a thinned asphalt called cutback asphalt, or an elastomer. [9] Membranes are rubberized asphalt or EPDM rubber. Rubberized products ...
Moisture vapor transmission rate (MVTR), also water vapor transmission rate (WVTR), is a measure of the passage of water vapor through a substance. It is a measure of the permeability for vapor barriers. There are many industries where moisture control is critical.
Paper-faced batts are vapor retarders, not vapor barriers. Foil-faced batts are vapor barriers. The vapor barrier must be installed toward the warm side. High-density fiberglass; Plastic fiber, usually made from recycled plastic. Does not cause irritation like fiberglass, but more difficult to cut than fiberglass. Not used in US.
This coating increases the barrier properties of the film, reducing the permeability of the film to oxygen and flavours and thus extending the shelf life of the food inside the package. It can also impart a high-gloss finish, which may be aesthetically pleasing and also provides a high degree of scuff resistance if applied over print.