Search results
Results from the WOW.Com Content Network
(Attack line) A use classification of a fire fighting hose connected to output of a pump or other pressure source (e.g., gravity). Fire hose used to apply water or other fire fighting agent directly to a fire or burning substance. Typically of 2 + 1 ⁄ 2 inches (64 mm) diameter or less in the United States. Historically 1.5 inch hose was the ...
Definition Attack Attack hose is a fabric-covered, flexible hose used to bring water from the fire pumper to the nozzle. This hose ranges in nominal inside diameter from 1.5 to 3 in (38 to 76 mm) and is designed to operate at pressures up to about 400 psi (2,760 kPa). The standard length is 50 ft (15.24 m). [12] Supply and relay hoses
Flexible suction hose, also known as a suction hose, is a specific type of rigid fire hose used in drafting operations. When using this technique, the fire engine draws water for fire fighting from an unpressurized supply, such as a portable water tank, pool, or other static water source, instead of drawing water from a pressurized water supply, such as a fire hydrant.
Essentials of Fire Fighting is a fire service training manual produced by Fire Protection Publications (FPP) and the International Fire Service Training Association (IFSTA). Fire Protection Publications is a department of Oklahoma State University College of Engineering, Architecture, and Technology (CEAT) [ 1 ] in Stillwater, Oklahoma [ 2 ...
1-inch hose with 1-8 NH NFPA threads (NFPA 1963 requirement; a.k.a. "Chemical Hose Thread" and "Booster Hose Thread" [7]; the chemical hose thread term likely originates from its use on chemical fire engines, an early firefighting device used from 1872 until the 1930s that used a combination of bicarbonate of soda and sulfuric acid to force ...
The following outline is provided as an overview of and topical guide to firefighting: . Firefighting – act of extinguishing fires.A firefighter fights these fires to prevent destruction of life, property and the environment.
A fog nozzle. A fog nozzle is a firefighting hose spray nozzle that breaks its stream into small droplets.By doing so, its stream achieves a greater surface area, and thus a greater rate of heat absorption, which, when compared to that of a smoothbore nozzle, speeds its transformation into the steam that smothers the fire by displacing its oxygen.
This method of storing hose is designed for rapid deployment of a hose line to attack a fire. In this manner, the hose is stored perpendicularly across the fire apparatus, usually above or adjacent to the pump panel, instead of the usual parallel storage in the rear. This allows the firefighter to pull the hose in the direction of the fire ...