Search results
Results from the WOW.Com Content Network
IPC is a trade association whose aim is to standardize the assembly and production requirements of electronic equipment and assemblies. IPC is headquartered in Bannockburn, Illinois, United States with additional offices in Washington, D.C. Atlanta, Ga., and Miami, Fla. in the United States, and overseas offices in China, Japan, Thailand, India, Germany, and Belgium.
Hermes is a machine-to-machine communication standard used in the SMT assembly industry. [1]IPC-HERMES-9852. It is a successor to the SMEMA standard, introducing improvements such as: simpler physical wiring (Ethernet), use of popular data transmission formats (TCP/IP and XML), reduced number of barcode scanners (required only once at the beginning of the line), transmission of board data ...
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.
The most common [citation needed] standards for conformal coating are IPC A-610 [9] and IPC-CC-830. [10] These standards list indications of good and bad coverage and describe various failure mechanisms, such as dewetting. Another type of coating called parylene is applied with a vacuum deposition process at ambient temperature. Film coatings ...
IEEE 200-1975 or "Standard Reference Designations for Electrical and Electronics Parts and Equipments" is a standard that was used to define referencing naming systems for collections of electronic equipment. IEEE 200 was ratified in 1975. The IEEE renewed the standard in the 1990s, but withdrew it from active support shortly thereafter.
Small Computer System Interface SCSI: Serial ATA (SATA) 3.1 [8] 2011/07/18 Shuttle PCB Assembly (SPA) for notebook motherboards: 2010 Simple Boot Flag Specification 2.1 2005/01/28 Simple Firmware Interface (SFI) 0.7 2009/07/31 System Management BIOS (SMBIOS) 2.7.1 2011/02/01 System Management Bus (SMBus) 2.0 2000/08/03 Trusted Platform Module ...
Automated optical inspection (AOI) is an automated visual inspection of printed circuit board (PCB) (or LCD, transistor) manufacture where a camera autonomously scans the device under test for both catastrophic failure (e.g. missing component) and quality defects (e.g. fillet size or shape or component skew). It is commonly used in the ...
The ISO/IEC 15288 Systems and software engineering — System life cycle processes is a technical standard in systems engineering which covers processes and lifecycle stages, developed by the International Organization for Standardization (ISO) and the International Electrotechnical Commission (IEC).