enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Pipecutter - Wikipedia

   en.wikipedia.org/wiki/Pipecutter

   There are two types of pipe cutters. Plastic tubing cutters, which resemble a pair of pruning shears, may be used for thinner pipes and tubes, such as sprinkler pipe. For use on thicker pipes, there is a pipecutter with a sharp wheel and adjustable jaw grips. These are used by rotating it around the pipe and repeatedly tightening it until it ...

3. Copper tubing - Wikipedia

   en.wikipedia.org/wiki/Copper_tubing

   While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   The bodies of fittings for pipe and tubing are often the same base material as the pipe or tubing connected: copper, steel, PVC, CPVC, or ABS. Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the ...

5. Pipe Cutting - Wikipedia

   en.wikipedia.org/wiki/Pipe_Cutting

   Plasma CNC Pipe Cutting . Hot cutting refers to a process in which materials are cut using a thermal torch. One of the most common techniques is oxy-fuel gas cutting, which is used extensively for cutting carbon and low-alloy steels. However, its efficiency diminishes as the alloy content of the material increases, limiting its applicability ...

6. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   Copper tube, CPVC, PeX and other tubing is measured nominally, basically an average diameter. These sizing schemes allow for universal adaptation of transitional fittings. For instance, 1/2" PeX tubing is the same size as 1/2" copper tubing. 1/2" PVC on the other hand is not the same size as 1/2" tubing, and therefore requires either a threaded ...

7. Knob-and-tube wiring - Wikipedia

   en.wikipedia.org/wiki/Knob-and-tube_wiring

   However, most existing residential knob-and-tube installations, dating to before 1940, have fewer branch circuits than is desired today. While these installations were adequate for the electrical loads at the time of installation, modern households use a range and intensity of electrical equipment unforeseen at the time.